Stillen SC Build 500 WHP?

EVOHUNTER

What do i have to do for the boost to come on sooner, different impeller?
i want 9-10 psi but just want the boost to come in early. any thoughts? 928 impeller?
also, what about the impeller shims?

__________________

Mr.Squeeze

You would have to copy my cog set up ANMVQ and a few other's have copied it already.The boost will come on a lot sooner with it you will have a better powerband with the cog pulleys.

__________________
Driven Motorsports Single Turbo 7675 T4 1.32 A/R 995WHP 780TQ

Nissan370

ok i am still having trouble understanding why the 9lb pulley is so small
the v3 can crank out up to 17psi and if its using a small pulley to start then what pulley is going to give me 15-16psi or close to that
i mean theres like what only one pulley smaller then 2.75

i know our heads flow well but i mean with the v2 and 2.95pulley i was seeing close to 550rwhp and 13.5psi on my mustang
i will figure it out i guess

__________________
370z vsr motorsports single turbo/built motor 9.1cr 525rwhp/450rwtq @ 10.5psi (stock maf maxed out)

Mr.Squeeze

The pulleys that Stillen use on the back of the blower and Jack shaft are big this slows the blower down.This is the reason why people have a problem making torque and Hp with the blower. The Stock pulley that comes with the kit is 3.12 that's not small at all either.

This is the reason why I put cog pulleys when I had the Stillen kit because I knew the blower was spinning slow. It is also the reason I made 465 Whp 360 TQ on a dynojet with the bigger pulley that came with the kit. The only way to get the blower to even try to crank out more psi is to use the cog pulleys that I used. But doing so you have to change a bunch of other things with the kit that have been talked about already.

I hope this helps you understand better.

__________________
Driven Motorsports Single Turbo 7675 T4 1.32 A/R 995WHP 780TQ