![]() |
Originally Posted by Jamaica@UAMotorsports I wonder if I can get over 400lbs or torque.. Yes, it's possible. Here's a graph of the Stage 2 with a smaller diameter pulley making
|
|
LinkBack | Thread Tools | Display Modes |
![]() |
#14 (permalink) |
Not an active Vendor. DO NOT BUY
Join Date: Sep 2009
Location: California
Posts: 391
Drives: '13 Hot Lava FR-S
Rep Power: 17 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
Yes, it's possible. Here's a graph of the Stage 2 with a smaller diameter pulley making 400wtq. Notice that the pull ends at 6200rpm because we stopped the pull...we were making 14psi of boost which was more than we wanted to make. The stage 2 is a real powerhouse once you start spinning it up.
Normally, we ship the Stage 2 with a 92mm pulley that is good for 500whp on 93 octane gas. Kosstick wanted less power and got the 96mm pulley instead. ![]() Last edited by Mike@GTM; 11-14-2011 at 03:57 PM. |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY GTM Twin Turbo Stage 2 Install!! | modme | Forced Induction | 59 | 07-09-2017 10:26 AM |
GTM Performance Engineering Stage 1 Turn key Supercharger kit In house Installation. | SAM@GTM | Forced Induction | 311 | 09-07-2011 03:42 AM |
GTM Performance Engineering Stage 1 Turn key Supercharger kit In house Install II. | SAM@GTM | Forced Induction | 254 | 08-11-2010 10:59 AM |
Nismo S-Tune install help | caneman88 | DIY Section (Do-It-Yourself) | 0 | 01-31-2010 07:53 PM |