GTM Performance Engineering Stage 1 Turn key Supercharger kit In house Install II.

LateralG'z · 08-08-2010, 12:11 PM

Sam advertise a 550 HP SC set-up, anyone taking a shot at it?

theDreamer · 08-08-2010, 12:11 PM

Quote:

Originally Posted by LateralG'z

Explain how LTH have anything to due with the PSI your blower is making. These are not related.

Really? I will let others explain it better than I can, but my exhaust is more free flowing which creates less pressure and lowers PSI.

LateralG'z · 08-08-2010, 12:12 PM

Quote:

Originally Posted by Red370

a larger pulley to bump the PSI up to 8-10 and tune? doesnt seem that difficult to me. TT is more headache than its worth. Especially in the long run when you start having boost leaks, fuel supply issues, impeller wear, etc. It will cost far less to maintain a supercharger setup than anything involving a turbo. Less parts means less areas to troubleshoot if a problem occurs.

theDreamer · 08-08-2010, 12:13 PM

Quote:

Originally Posted by LateralG'z

Sam advertise a 550 HP SC set-up, anyone taking a shot at it?

Where does it say that?

theDreamer · 08-08-2010, 12:14 PM

Quote:

Originally Posted by LateralG'z

It is not just a simple upgrade the pulley and tune, that is one factor. You also have to calculate in the efficiency of the unit, engine capabilities, etc.

Red370 · 08-08-2010, 12:15 PM

Quote:

Originally Posted by theDreamer

Where does it say that?

thats probably a bhp number.

LateralG'z · 08-08-2010, 12:16 PM

Quote:

Originally Posted by theDreamer

Really? I will let others explain it better than I can, but my exhaust is more free flowing which creates less pressure and lowers PSI.

Your not on a TT set-up. Your blower is driven off the engine so your boost is related to the blower size and pulley set-up to achieve a certain amount of boost. A TT is using exhaust gas. So I am confused how your LTH have anything to do with your PSI rating.

theDreamer · 08-08-2010, 12:17 PM

Quote:

Originally Posted by LateralG'z

Your not on a TT set-up. Your blower is driven off the engine so your boost is related to the blower size and pulley set-up to achieve a certain amount of boost. A TT is using exhaust gas. So I am confused how your LTH have anything to do with your PSI rating.

Go read up on superchargers a bit more I think you have some facts confused.

theDreamer · 08-08-2010, 12:18 PM

Quote:

Originally Posted by Red370

thats probably a bhp number.

Just checked, the stage 1 setup is rated up to 550HP (flywheel).

LateralG'z · 08-08-2010, 12:19 PM

GT Motorsports: 370Z Supercharger system development
We are please to announce The GTM supercharger system Development for the 370Z . The GTM supercharged 370z project was under way back in the begging of the year .

Since we are completely done with our twin turbo system development that was released last month, We will be focusing on the the supercharged system. We are committed and planing on displaying both of our force induction system Solution for the 370Z @ sema 2009 .

Our GTM supercharger system will be utilizing the Rotrex C38 supercharger, The Key to the Rotrex supercharger's unique compactness, efficiency, low noise and reliability is its state of the art traction drive technology.

Great speeds and low noise are just some of the advantages of traction drives over traditional gear transmissions. Traction drives transmit power through friction forces between its rolling elements.

The Rotrex patented traction drive uses an elastic annulus with a small pre-span to secure contact between the roller planets and the sun shaft with a reasonable force. The patented "ramp effect" increases efficiency and reliability in the transmission by regulating the torque transfer capability on demand through self-adjusting planet geometry.

To enhance performance, the Rotrex traction drive uses a special traction fluid. These fluids are a new family of synthetic hydrocarbon oils and greases offering a series of unique performance advantages. Developed specially for its use in Rotrex superchargers, the SX100 momentarily increases viscosity under high surface pressure, enhancing the traction drive performance by securing the optimum friction between rolling elements while cooling and protecting the system.

This traction drive combined with the latest technology in centrifugal compression, characterized by high adiabatic efficiency and low noise, gives Rotrex superchargers an exceptional competitive edge over any other forced induction solution.

The GTM Supercharger Will Have three different stages to offer

Stage one will come with C38-61 Trim up to 550 HP
Stage two will come with C38-71 trim up to 590 HP
Sage three will come with C38-81 trim up to 630 HP

Here is some pics of the the Rotrex C38-61

Go read SAM's Supercharger announcement.

theDreamer · 08-08-2010, 12:20 PM

Quote:

Originally Posted by LateralG'z

GT Motorsports: 370Z Supercharger system development
We are please to announce The GTM supercharger system Development for the 370Z . The GTM supercharged 370z project was under way back in the begging of the year .

Since we are completely done with our twin turbo system development that was released last month, We will be focusing on the the supercharged system. We are committed and planing on displaying both of our force induction system Solution for the 370Z @ sema 2009 .

Our GTM supercharger system will be utilizing the Rotrex C38 supercharger, The Key to the Rotrex supercharger's unique compactness, efficiency, low noise and reliability is its state of the art traction drive technology.

Great speeds and low noise are just some of the advantages of traction drives over traditional gear transmissions. Traction drives transmit power through friction forces between its rolling elements.

The Rotrex patented traction drive uses an elastic annulus with a small pre-span to secure contact between the roller planets and the sun shaft with a reasonable force. The patented "ramp effect" increases efficiency and reliability in the transmission by regulating the torque transfer capability on demand through self-adjusting planet geometry.

To enhance performance, the Rotrex traction drive uses a special traction fluid. These fluids are a new family of synthetic hydrocarbon oils and greases offering a series of unique performance advantages. Developed specially for its use in Rotrex superchargers, the SX100 momentarily increases viscosity under high surface pressure, enhancing the traction drive performance by securing the optimum friction between rolling elements while cooling and protecting the system.

This traction drive combined with the latest technology in centrifugal compression, characterized by high adiabatic efficiency and low noise, gives Rotrex superchargers an exceptional competitive edge over any other forced induction solution.

The GTM Supercharger Will Have three different stages to offer

Stage one will come with C38-61 Trim up to 550 HP
Stage two will come with C38-71 trim up to 590 HP
Sage three will come with C38-81 trim up to 630 HP

Here is some pics of the the Rotrex C38-61

Go read SAM's Supercharger announcement.

Flywheel numbers, read my statement above.

LateralG'z · 08-08-2010, 12:25 PM

That sucks sort of that each stage upgrade requires that you have to due all that work for more power. Stillen's SC compressor is rated to 700HP so all you have to due is change the pulley and tune to make the more HP and TQ not rebuild the kit.

Zsteve · 08-08-2010, 12:29 PM

Quote:

Originally Posted by LateralG'z

That sucks sort of that each stage upgrade requires that you have to due all that work for more power. Stillen's SC compressor is rated to 700HP so all you have to due is change the pulley and tune to make the more HP and TQ not rebuild the kit.

A tune that isnt working right now. And if I was to go to 700 HP I would do a TT for that much power and get the tq with it.

theDreamer · 08-08-2010, 12:29 PM

Quote:

Originally Posted by LateralG'z

That sucks sort of that each stage upgrade requires that you have to due all that work for more power. Stillen's SC compressor is rated to 700HP so all you have to due is change the pulley and tune to make the more HP and TQ not rebuild the kit.

Why are you even in this thread, all you have done is start trash talk?

Zsteve · 08-08-2010, 12:32 PM

Is GTM tuning their own kit or do they have a company doing that for them?

08-08-2010, 12:11 PM	#196 (permalink)
LateralG'z Track Member Join Date: Nov 2009 Location: Oklahoma Posts: 876 Drives: 370z Rep Power: 17	Sam advertise a 550 HP SC set-up, anyone taking a shot at it? __________________ 2010 Mag Black, 6MT,

08-08-2010, 12:19 PM	#205 (permalink)
LateralG'z Track Member Join Date: Nov 2009 Location: Oklahoma Posts: 876 Drives: 370z Rep Power: 17	GT Motorsports: 370Z Supercharger system development We are please to announce The GTM supercharger system Development for the 370Z . The GTM supercharged 370z project was under way back in the begging of the year . Since we are completely done with our twin turbo system development that was released last month, We will be focusing on the the supercharged system. We are committed and planing on displaying both of our force induction system Solution for the 370Z @ sema 2009 . Our GTM supercharger system will be utilizing the Rotrex C38 supercharger, The Key to the Rotrex supercharger's unique compactness, efficiency, low noise and reliability is its state of the art traction drive technology. Great speeds and low noise are just some of the advantages of traction drives over traditional gear transmissions. Traction drives transmit power through friction forces between its rolling elements. The Rotrex patented traction drive uses an elastic annulus with a small pre-span to secure contact between the roller planets and the sun shaft with a reasonable force. The patented "ramp effect" increases efficiency and reliability in the transmission by regulating the torque transfer capability on demand through self-adjusting planet geometry. To enhance performance, the Rotrex traction drive uses a special traction fluid. These fluids are a new family of synthetic hydrocarbon oils and greases offering a series of unique performance advantages. Developed specially for its use in Rotrex superchargers, the SX100 momentarily increases viscosity under high surface pressure, enhancing the traction drive performance by securing the optimum friction between rolling elements while cooling and protecting the system. This traction drive combined with the latest technology in centrifugal compression, characterized by high adiabatic efficiency and low noise, gives Rotrex superchargers an exceptional competitive edge over any other forced induction solution. The GTM Supercharger Will Have three different stages to offer Stage one will come with C38-61 Trim up to 550 HP Stage two will come with C38-71 trim up to 590 HP Sage three will come with C38-81 trim up to 630 HP Here is some pics of the the Rotrex C38-61 Go read SAM's Supercharger announcement. __________________ 2010 Mag Black, 6MT,

08-08-2010, 12:25 PM	#207 (permalink)
LateralG'z Track Member Join Date: Nov 2009 Location: Oklahoma Posts: 876 Drives: 370z Rep Power: 17	That sucks sort of that each stage upgrade requires that you have to due all that work for more power. Stillen's SC compressor is rated to 700HP so all you have to due is change the pulley and tune to make the more HP and TQ not rebuild the kit. __________________ 2010 Mag Black, 6MT,

08-08-2010, 12:32 PM	#210 (permalink)
Zsteve A True Z Fanatic Join Date: Sep 2009 Location: TX Posts: 3,298 Drives: the 2 balled club Rep Power: 22	Is GTM tuning their own kit or do they have a company doing that for them? __________________ 2010 LS3 C6 Silver coupe corvette

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GTM Performance Engineering 370Z SUPERCHARGER KIT PRESS RELEASE	SAM@GTM	Forced Induction	1161	02-16-2014 09:21 PM
GTM Performance Engineering Stage 1 Turn key Supercharger kit In house Installation.	SAM@GTM	Forced Induction	311	09-07-2011 04:42 AM
GTM Performance Engineering & Forged Performance	azn370z	Forced Induction	59	04-14-2010 01:07 AM