Bank 1 Lean/AFR Fluctuations

Blandino

I just installed Topgunz Gen 1 SC kit and have Seb remote tuning. On startup/idle, bank 1 is lean and the AFR is fluctuating quite a bit at idle. It has the new iridium plugs that came with the kit, new ID1050X injectors, CJM billet fuel rails, S1.SE return kit with 340 aero/twin pump with the regulator set at 52psi before the vacuum line was attached.

So far I've checked Y-pipe to throttle body hose clamps and TB torque. I've also swapped the O2 sensors and checked the LT headers for any leaks, but the problem remains on bank 1. Right now I have the Stillen intake manifold off and will be swapping the coil packs & injectors to bank 2 to see if the problem follows. I did wash & reuse the old manifold gasket, but I ordered a new one for the next time it came off so that will be getting replaced as well. Hoping the issue goes away or it moves to bank 2 so I won't have to pull this manifold again to access everything.

Is there anything I may have overlooked that could cause the lean conditions on only bank 1, or anything else I should do before I put everything back together?

Attached Images

1.jpg (65.8 KB, 17 views)

DrBacon

If there was any sort of leak it would affect both banks. Maybe a bad injector?

Blandino

I was thinking it'd be an injector as well since there were no issues prior to the install with the coil packs. Just got done swapping everything over to the other bank and no issues on either now. One thing I noticed was that when I was removing the PnP adapters, two of them just came right off while I was wiggling the cables. I probably should've caught that on the install.

The only thing I changed was cutting the factory harness and crimping the uscar connectors on, using some tacky gasket sealant on the intake manifold & TB's, and hitting the injectors with the air compressor.

Attached Images

Logging Update.jpg (72.4 KB, 13 views)