can you build a 1000whp 2400lb Factory Five Daytona Coupe now

Noop, not my coup of tea. Saw one in Ocala at the 1/2 mile event. He was slow. 148mph or so.

I’m not asking about information to learn from, I’m just curious on what platform you end up with. You have stated before you owned numerous Zs throughout your life… so what is next?


Sent from my iPhone using Tapatalk

Well, I don't care for the new ones if that is what you are asking. They are Ugly. I have no plans.

10 sec Ram dually would be cool…:stirthepot:

LOL

If anybody wants a SOHO intake manifold, just PM me.

Watch this R32 GTR check out. Impressive to be able to have 1100whp and be able to turn a corner. Too bad he lost it.

This track is a favorite of mine! Love the long stretches and the tight technical sections.

In case you haven't figured it it out. I am not done yet. You will just have to wait and see.

Yes, my VQ is back together and headed back. I nicked a headgasket on cylinder #4. We have some ideas of what happened but with Ecutek, the data is lacking big time. The heads did not yield and just needed a .002 clean up cut. My L19 head studs were still torqued to what they were set to before. They didn't move at all. Yes, Mazworx is my builder and will always be. Mark is a good dude. I paid for it to be repaired because it wasn't his fault.

The only odd issue I had was with my Suckerpunch oil pump. For the 2nd time on 2 different oil pumps it showed some weird wear. I installed a Nissan Nismo oil pump this time. I don't trust any aftermarket oil pump company after this. Nissan only from now on.

6th time's the charm!

May not turn it up. We will see what the data says. Ecutek can pound sand. I will not be using that again.