Turbo oil drain problems w/AAM kit

Jayhovah · 09-26-2017, 11:00 AM

Quote:

Originally Posted by dragonbreath

The drivers side turbo uses a 45 degree fitting for the oil drain, and due to the starter has to be angled somewhat away from the motor. So the line has to curve back to the motor and then somewhat levels out. I've tried to see if I could change the routing of the line to make it better but due to the close proximity of the oil pan to the subframe, the line will always rest on the subframe. It's driving me crazy.

I've done a compression test and all of my compression rates are very good. I'm going to see if I can borrow a leak down tester also to make sure. When I got tuned I was having an issue with the dipstick blowing out... that's why I removed the AAM pcv setup. I haven't had any issues since I removed them. Before I could drive the car and when I parked it and turned it off, I could hear burbling from the motor. When I pulled the dipstick I would hear a rush of air. That has been alleviated but I'm still going to see if for some reason I'm getting leakage through the cylinders causing the line not to drain properly. I'm pretty certain I don't have any issues... but I'm unsure what to do next. I would like to avoid having to do a scavenge pump because I like simplicity.

I did talk to AAM and they said that according to Borg Warner, it's almost impossible for the turbo seals to go bad due to the design. Something about the seals being similar to a piston ring. They suggested that I clean it out and try it again. That didn't work for me obviously lol.

Sent from my iPhone using Tapatalk

That is kind of scary with the crank case being pressurized and blowing the dip stick out. I'll bet that was quite a surprise the first time!!! Did it just pop out or did it like fire across the room? I feel like that would give me a pretty fierce case of the giggles.

Since you are finding oil in the charge pipe and don't have PCV plumbed, I agree its 100% coming from the turbo, I wouldn't worry about the motor at all. Maybe you have a defect or blockage in the return line plumbing?

One test I can think of is to swap the pass/drivers side turbos... but it would probably be a ton of work... it would rule out a turbo defect though.

You mentioned the problem comes with throttle. Strictly with throttle? Or with RPM? Happens regardless of whether the oil is cold or hot? Wondering if it is dependent on oil pressure.

What size is the return line? Looks like some setups use some relatively small AN lines.... on my kit the returns are some pretty fat hoses which are almost like reservoirs in and of themselves.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Multiple problems with my FI twin turbo 370z	LJTTZ	Forced Induction	8	10-21-2016 06:19 PM
STS turbo problems...FML!!!	1_Stealth_Z	Forced Induction	21	01-16-2014 03:11 AM
oil filter mag & mag drain plug, which one and where to buy?	Z11	Nissan 370Z General Discussions	32	12-11-2013 02:54 PM
Plans of going FI down the drain	zuperman 370	Nissan 370Z General Discussions	1	08-13-2011 08:26 PM