|
Reset the ECU, went through the peddle release, tb closed position, and volume relearn. I used NDISIII to start the relearn. Waited for idle to get to 650 +/- 50
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
09-28-2017, 07:16 PM
|
#8 (permalink) |
|
Track Member
Join Date: Jun 2016
Location: Massachusetts
Posts: 724
Drives: 07' Nismo, 14' Nismo
Rep Power: 29262   |
Reset the ECU, went through the peddle release, tb closed position, and volume relearn. I used NDISIII to start the relearn. Waited for idle to get to 650 +/- 50 and then shut the car off.
Started it back up... idle like a kitten. Great. Went to drive around the block... idle surge again. Was curious about the purge valve connections and double checked the Stillen directions for it. Left side of the valve goes to back of the manifold. Other side goes to the EVAP. So everything looks good. arrrrrgggggghhhhhh... back to the drawing board. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Idle pulley for my Stillen SC install | wideglideleon | Forced Induction | 2 | 06-26-2017 06:21 PM |
| Stillen Supercharger Install (2010 Nissan 370Z) | Nik@SOHO | Forced Induction | 18 | 05-29-2017 09:30 PM |
| Stillen Supercharger post-install issues | WillVHR | Forced Induction | 6 | 01-29-2016 07:49 PM |
| Stillen Supercharger Froozen Boost Intercooler Install | EVOHUNTER | DIY Section (Do-It-Yourself) | 0 | 05-16-2015 11:01 AM |
| Starting problem after stillen supercharger install | fastlandyacht | Forced Induction | 5 | 08-27-2012 02:57 PM |
8Likes
Threaded Mode
