Comp turbo failure less than a mile

knuckles899 · 08-06-2017, 03:26 AM

****** Please read post #79 and #82 for explanation for how this was a install error and not a manufacturer defect*******

So for the last 3 months I have been meticulously installing a Boosted Performance turbo kit for my HR.....works been really busy so I've been tackling the install by myself when I have time. Prior to doing the turbo install I dropped the transmission and put in a Southbend stage 3 daily clutch and DXD flywheel, Zspeed HD slave, wilwood MC ect ect.

Today I finally got to the point where I could actually fire her up and drive it just a little bit to check for leaks.......................after letting it idle for 5 mins I decided to go around the block lightly....I only had the base map flashed provided by Sasha and Vince at RT tuning so I kept it light footed.....................

This is where I get really sad now, I made it only about an eighth mile from my house and I started to notice a kind of whirling or howling sound coming from the Comp Turbo (oil-less provided with the boosted performance turbo kit) I turned around and parked it back in the garage and started checking everything out.

I noticed when I removed the air filter for the turbo it appears that the impeller blades have somehow made a grove into the turbo inlet housing....I'll upload pics tomorrow.

What would of caused this so fast? not even getting on it....I assume all the metal shards from the impeller and inlet housing are now located in my engine now......

Sorry for the long post..............just utterly disappointed....didn't now what else to do....its not even about the money.....just all the time I have spent with all this......I guess literally everyone was right about my 350z and what a waste of time and money it would be doing all this to it.

My moping session is over ill get pics soon FML.

jchammond · 08-06-2017, 04:31 AM

wow,,,did you loosen any clamps on turbo to clock it/turn it for piping alignment?
i'm not familiar with that turbo...as you stated oil-less.

jchammond · 08-06-2017, 04:37 AM

1st Turbo i've ever seen that uses high temp grease for the bearings...I'm sure it had to come pre-lubed.

knuckles899 · 08-06-2017, 05:05 AM

Yeah, it comes pre-greased......i verified by calling CompTurbo a couple months ago.

knuckles899 · 08-06-2017, 05:06 AM

Heres the pics

https://ibb.co/dWovev
https://ibb.co/fTmyzv
https://ibb.co/mdUU6a
https://ibb.co/i9LQev
https://ibb.co/gopCRa
https://ibb.co/myYiXF

20170806_010005 by Brandon Curry, on Flickr

20170806_005956 by Brandon Curry, on Flickr

20170806_005941 by Brandon Curry, on Flickr

20170806_005913 by Brandon Curry, on Flickr

20170806_005907 by Brandon Curry, on Flickr

knuckles899 · 08-06-2017, 05:13 AM

Quote:

Originally Posted by jchammond

wow,,,did you loosen any clamps on turbo to clock it/turn it for piping alignment?
i'm not familiar with that turbo...as you stated oil-less.

I loosened the housing to spin it slightly but that is pretty common in order to align/clock the turbo.

jchammond · 08-06-2017, 06:03 AM

That's crazy; hopefully it didn't force particles into your engine; your intercooler may have caught them.
Pics look as though it's coming apart-wish you Luck on some warranty.
That really sux; as I can relate by performing all of my wrench turning.

Jinxx · 08-06-2017, 07:11 AM

Hmmm that makes me wanna check mine now ....I did noticed it howl some and heard some strange noises that I have been looking for...but most have been exhaust vibration ..haven't removed the turbo tho I have about 50 miles on it now.....just making a observation from the pics ...it kinda looks like something mine have been sucked in damaging the blade

Senna-F1 · 08-06-2017, 11:46 AM

Our first Comp Turbo review, lovely. And this is a 350z? Still wondering where all the 370z guys are that have this turbo. I haven't seen anything from them, and it's been awhile since they were sold.

Thank you Knuckles for giving us your experience

knuckles899 · 08-06-2017, 12:21 PM

Quote:

Originally Posted by Senna-F1

Our first Comp Turbo review, lovely. And this is a 350z? Still wondering where all the 370z guys are that have this turbo. I haven't seen anything from them, and it's been awhile since they were sold.

Thank you Knuckles for giving us your experience

Yeah 08 350z HR. At this point I feel as if I've been sold a vat of snake oil from Comp Turbo......

I'm curious on Sasha's opinion about this.....since he backed supplying Comp oil-less turbos with his kit.

Jinxx · 08-06-2017, 12:44 PM

How did the car sound when it was idling...

Elmo370z · 08-06-2017, 01:29 PM

Damnit

Elmo370z · 08-06-2017, 01:30 PM

I was planning on buying this kit

Elmo370z · 08-06-2017, 01:58 PM

Quote:

Originally Posted by Jinxx

Hmmm that makes me wanna check mine now ....I did noticed it howl some and heard some strange noises that I have been looking for...but most have been exhaust vibration ..haven't removed the turbo tho I have about 50 miles on it now.....just making a observation from the pics ...it kinda looks like something mine have been sucked in damaging the blade

Let's us know

knuckles899 · 08-06-2017, 02:03 PM

Quote:

Originally Posted by Jinxx

How did the car sound when it was idling...

Normal for a single exit exhaust.

08-06-2017, 03:26 AM	#1 (permalink)
knuckles899 Base Member Join Date: Dec 2016 Location: NoR CaL Posts: 54 Drives: 08 350z Hr Rep Power: 8	Comp turbo install Error **** Please read post #79 and #82 for explanation for how this was a install error and not a manufacturer defect***** So for the last 3 months I have been meticulously installing a Boosted Performance turbo kit for my HR.....works been really busy so I've been tackling the install by myself when I have time. Prior to doing the turbo install I dropped the transmission and put in a Southbend stage 3 daily clutch and DXD flywheel, Zspeed HD slave, wilwood MC ect ect. Today I finally got to the point where I could actually fire her up and drive it just a little bit to check for leaks.......................after letting it idle for 5 mins I decided to go around the block lightly....I only had the base map flashed provided by Sasha and Vince at RT tuning so I kept it light footed..................... This is where I get really sad now, I made it only about an eighth mile from my house and I started to notice a kind of whirling or howling sound coming from the Comp Turbo (oil-less provided with the boosted performance turbo kit) I turned around and parked it back in the garage and started checking everything out. I noticed when I removed the air filter for the turbo it appears that the impeller blades have somehow made a grove into the turbo inlet housing....I'll upload pics tomorrow. What would of caused this so fast? not even getting on it....I assume all the metal shards from the impeller and inlet housing are now located in my engine now...... Sorry for the long post..............just utterly disappointed....didn't now what else to do....its not even about the money.....just all the time I have spent with all this......I guess literally everyone was right about my 350z and what a waste of time and money it would be doing all this to it. My moping session is over ill get pics soon FML. Last edited by knuckles899; 08-22-2017 at 10:00 PM. Reason: Title edit

08-06-2017, 04:31 AM	#2 (permalink)
jchammond A True Z Fanatic Join Date: Nov 2014 Location: South Carolina Age: 58 Posts: 15,204 Drives: 13’ 370Z TS 7A/T Rep Power: 2684394	wow,,,did you loosen any clamps on turbo to clock it/turn it for piping alignment? i'm not familiar with that turbo...as you stated oil-less. __________________ MazWorx built long block \| FI-TT-100 Stage 2.75 \| IPT built 7A/T http://www.the370z.com/members-370z-...s-musings.html

08-06-2017, 04:37 AM	#3 (permalink)
jchammond A True Z Fanatic Join Date: Nov 2014 Location: South Carolina Age: 58 Posts: 15,204 Drives: 13’ 370Z TS 7A/T Rep Power: 2684394	1st Turbo i've ever seen that uses high temp grease for the bearings...I'm sure it had to come pre-lubed. __________________ MazWorx built long block \| FI-TT-100 Stage 2.75 \| IPT built 7A/T http://www.the370z.com/members-370z-...s-musings.html

08-06-2017, 05:06 AM	#5 (permalink)
knuckles899 Base Member Join Date: Dec 2016 Location: NoR CaL Posts: 54 Drives: 08 350z Hr Rep Power: 8	Heres the pics https://ibb.co/dWovev https://ibb.co/fTmyzv https://ibb.co/mdUU6a https://ibb.co/i9LQev https://ibb.co/gopCRa https://ibb.co/myYiXF 20170806_010005 by Brandon Curry, on Flickr 20170806_005956 by Brandon Curry, on Flickr 20170806_005941 by Brandon Curry, on Flickr 20170806_005913 by Brandon Curry, on Flickr 20170806_005907 by Brandon Curry, on Flickr Last edited by knuckles899; 08-06-2017 at 10:40 AM. Reason: post pics

08-06-2017, 06:03 AM	#7 (permalink)
jchammond A True Z Fanatic Join Date: Nov 2014 Location: South Carolina Age: 58 Posts: 15,204 Drives: 13’ 370Z TS 7A/T Rep Power: 2684394	That's crazy; hopefully it didn't force particles into your engine; your intercooler may have caught them. Pics look as though it's coming apart-wish you Luck on some warranty. That really sux; as I can relate by performing all of my wrench turning. __________________ MazWorx built long block \| FI-TT-100 Stage 2.75 \| IPT built 7A/T http://www.the370z.com/members-370z-...s-musings.html

08-06-2017, 05:05 AM	#4 (permalink)
knuckles899 Base Member Join Date: Dec 2016 Location: NoR CaL Posts: 54 Drives: 08 350z Hr Rep Power: 8	Yeah, it comes pre-greased......i verified by calling CompTurbo a couple months ago.

08-06-2017, 07:11 AM	#8 (permalink)
Jinxx Track Member Join Date: Dec 2015 Location: South Carolina Posts: 699 Drives: 2017 nismo 370z Rep Power: 3375	Hmmm that makes me wanna check mine now ....I did noticed it howl some and heard some strange noises that I have been looking for...but most have been exhaust vibration ..haven't removed the turbo tho I have about 50 miles on it now.....just making a observation from the pics ...it kinda looks like something mine have been sucked in damaging the blade Last edited by Jinxx; 08-06-2017 at 12:40 PM.

08-06-2017, 11:46 AM	#9 (permalink)
Senna-F1 Enthusiast Member Join Date: Jun 2016 Location: Cary, NC Age: 54 Posts: 425 Drives: 370SC,EliseSC,MR2T Rep Power: 50	Our first Comp Turbo review, lovely. And this is a 350z? Still wondering where all the 370z guys are that have this turbo. I haven't seen anything from them, and it's been awhile since they were sold. Thank you Knuckles for giving us your experience 370Zsteve likes this.

08-06-2017, 12:44 PM	#11 (permalink)
Jinxx Track Member Join Date: Dec 2015 Location: South Carolina Posts: 699 Drives: 2017 nismo 370z Rep Power: 3375	How did the car sound when it was idling... 370Zsteve likes this.

08-06-2017, 01:29 PM	#12 (permalink)
Elmo370z A True Z Fanatic Join Date: Apr 2013 Location: st. petersburg Posts: 5,709 Drives: 09 nissan 370z Sp M6 Rep Power: 295378	Damnit

08-06-2017, 01:30 PM	#13 (permalink)
Elmo370z A True Z Fanatic Join Date: Apr 2013 Location: st. petersburg Posts: 5,709 Drives: 09 nissan 370z Sp M6 Rep Power: 295378	I was planning on buying this kit

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Another DIY Twin Turbo kit (COMP oil-less turbos)	thangcu35	Forced Induction	138	03-16-2018 11:30 AM
[FOR SALE] (2) Comp Turbo CT4X 6262 3BB Fully customized!!!	Nismo350z#310	Parts for sale (Private Classifieds)	11	12-02-2016 06:23 AM
For Sale / Trade: 2012 370 Twin Turbo - 6MT - Touring + Sport - All Options - 8K Mile	Nixlimited	Cars for sale (Private Classifieds)	27	10-06-2015 07:53 AM
Best 0-60 (1/8 mile) / (1/4 mile) times with 2013 7SP AT	kenwood	New 370Z Owner	1	11-18-2012 05:20 PM
3 way comp placement	samb03	Audio & Video	0	03-02-2011 12:46 AM