Stillen S.C. Plenum charge assembly coolant leak during WOT on dyno

Rusty

Does the Stillen water pump shut off with the ignition? This is where you might have a problem. If it ran for a little bit after you stopped the engine. It may have put enough coolant into the intake, and chambers to hydro-lock on the next start up. Pull all the plugs and crank the engine over to blow out any coolant that may have collected or pooled. Then spray a little oil in each chamber to coat the cylinder walls.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

NissanTracker

Yes, the relay was wired in parallel with the fuel pump. Car shuts off, pump shuts off.

NissanTracker

phunk hooked me up with a new charge core, so once that arrives... i'll install it back in the plenum.

I should be getting pictures today/tomorrow from Kaizen's showing damage to the core. Unfortunately, the price to play got steep with this one. They run a tight shop there, but absolutely professional. Was glad they took on my project.

acorona370

That was my charger core hope it gets you back up and running !

NissanTracker

Ahh, the anonymous donor. Thanks for letting it go. Saved my butt at this point.

Jayhovah

Now your cars will be forever linked.

__________________
2013 Gun Metallic Sport - Gamma V3 Twin Turbogized
DIY Gamma V3 TT Install * Jayhovah's Gamma V3 TT Install Pic'Z and Vid'Z * DIY: Washer Reservoir for the Boosted

Rusty

Transplant donor.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

NissanTracker

Still no word. Cooler will be in end of day tomorrow. So earliest I can get it over at Kaizen's is Monday. The waiting game..... ugh. My daily driver is an 03 Toyota Rav 4. I'm starting to get sick of it. Having Z withdrawals. Worse, I'm hoping for 400wHP. This will be a significant change that I have always waiting for ;-)

acorona370

i get my car back Monday hopefully too!


Good Luck!

NissanTracker

Well, just an update. Compression test came back with 205->210 across the board. Motor is still in great condition. They put in the new charge cooler and it will get dyno tuned on Wednesday. I'll post numbers if all goes well

@acorona370, Did you get your Z back already?

NissanTracker

Was supposed to get a call from them earlier in the day, but nothing. Hopefully tomorrow. I hate the waiting game. The Z has been at Kaizens for a month already.

Rusty

Hurry up and wait. It's fact of life.

__________________

浪人 - 殺し屋
"The Difficult Anytime, The Impossible By Appointment Only"
http://www.the370z.com/members-370z-...o-journal.html

NissanTracker

Haha... yup. In their defense, I was only there for a tune. Of course for unforeseen events, they were able to squeeze my car in a couple weeks later. Luckily they are 2 weeks out in scheduling. Granite state dyno (the only other alternative) has a 2->3 month waiting period

acorona370

Saddly im still down too. im having it remote tuned by seb and he says we might have a software problem. Charles said he sent some info over to ECUTEk for them to review.

NissanTracker

I just got the results of mine today. Only 350wHP. Granted, I have a 350z HR... but they couldn't get any more power out of it. I believe it is the exhaust system. I have high flow cats and a tanabe Y pipe going into the stock Nismo center section and muffler.

Normally it should have seen around 375wHP (assuming I had a true dual exhaust).