New FI club member

phunk

I just saw this post. Thanks for sharing all that. Great post. I will save the link to refer to people in the future.

__________________

TBatt

With all of the things I have done to my Z the exhaust system which so sweet at first had become a drone monster. From 2K-3K rpm, the exhaust would drone at highway speeds and get really loud during regular driving. I did some searching on the forum and saw an article about adding Helmholtz resonators to reduce the 130-160Hz noise by pressure wave cancellation. Well, I added them in and they DO REDUCE the drone.

They are quite simple in design but a bear to install. The fab shop I use came up with a solution that was way easier than T-ing off the exhaust tip area. The system clears everything under the car and the drone has been reduced by at least 50%.

The resonators are 28 inches long and 2.25 inches in diameter. All 304 stainless.

Attached Images

	20180124_100517_resized.jpg (472.5 KB, 16 views)
	20180124_160058_resized.jpg (555.9 KB, 19 views)
	20180124_160111_resized.jpg (619.5 KB, 18 views)
	20180124_160125_resized.jpg (552.8 KB, 9 views)
	20180124_160140_resized.jpg (621.6 KB, 12 views)

__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!