New FI club member

TBatt

There is one thing that I have gotten very good at, finishing a Z project in time for a rain storm........

August in Alabama means a 75% chance of rain every day around 4-7pm. At least the showers cool things down some but the humidity! You can work up a sweat just standing.

Well, the 8 to 7 rib belt mod and additional jack shaft pulley have been installed. I did wound up making a custom spacer out of 6061 aluminum bar stock. I just didn't like all of the washers acting as spacers, it just wasn't worthy of my Z!

The HD Fleet belt is slightly thicker than a regular Gates Micro-V so I would think twice about using one. I will, however check with the Gates racing division for the racing version of the K080188 belt in BLUE to match my Z.

Pauly Z has already posted a picture of the setup but this is what mine looks like IN RACING GREEN.

The swap out doesn't take long at all and the belt, pulley and hardware runs about $100 and it should not slip! Look at the wrap around of the belt on the jack shaft pulley. Awesome!

Tomorrow the weather is looking good in the morning so I will try another log run and see what happens. Wish me luck!

Attached Images

	20160820_141827_resized.jpg (484.4 KB, 50 views)
	20160820_141816_resized.jpg (449.9 KB, 59 views)

__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!