New FI club member

TBatt

Got all of the hoses on!!

I could not get the 45 degree coupler to work coming off of the SC so I used a 90 and it worked perfect. I also managed to get the pinch weld cleared out from under the SC by careful use of my saws-all and dremel tool. Mainly I cut the pinch weld on both sides of the Volute exhaust and then used the dremel tool with a carbide cutting disc to cut partially through the metal so I could grab it with a needle nose vise grip and simply fold the metal over. Took about 15 minutes and I did not have to remove the SC.....again.

You can see my BOV muffler. I hope it works.

I need to get a 3/8 barbed union to connect two water lines together and I think I'm done installing. Far from finished yet though. Tomorrow night will be the ECU reflash and water lines then I'll be ready to fire the beast up.

Time for a tall rum and coke and then a shower.

Attached Images

	DSC03635.JPG (70.7 KB, 47 views)
	DSC03636.JPG (79.1 KB, 43 views)
	DSC03637.JPG (59.4 KB, 52 views)
	DSC03638.JPG (52.8 KB, 46 views)
	DSC03639.JPG (46.7 KB, 38 views)
	DSC03640.JPG (57.2 KB, 35 views)
	DSC03641.JPG (61.1 KB, 37 views)
	DSC03642.JPG (63.8 KB, 36 views)
	DSC03643.JPG (61.7 KB, 38 views)

__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!