Topgunz - air to air upgrade

cupcakez

I'm going to test the 1/4 mile once my car is up and running again hopefully by the end of this month latest (This includes the engine swap with a bunch of new upgrades added with a mean ECUtek Tune while taking off the dreaded bad Stillen tune!
I will be running 91 octane at first, since my car won't be tuned or capable of efficiently holding E85 yet.
So once I get those results i will definitely post them!!

The following upgrades that will be on the car when the car is up and running again is as follows:

[x] KW V3 Suspension
[x] Quaife LSD
[x] X pipe, Magnaflow custom exhaust
[x] Fresh GTR Spark Plugs
[x] Fresh O2 Sensors
[x] Fresh 1050x ID
[x] 928 Exclusive Impeller & Double High Speed Bearings for V3 SCi
[x] Upgraded V3 SCi Supercharger
[x] TopgunZ full A2A Conversion Kit
[x] ATI Super Damper Pulley; Stock Size
[x] Fresh YellowTop Optima Battery
[x] Whiteline Differential Bushings
[x] 3.0" & 3.47" Supercharger Side Pulleys
[x] 9psi Pulley on Serpentine side
[x] Z1 High Pressure Radiator Cap
[x] Z1 Thermal Gold Reflective Tape
[x] Fresh OEM Nissan Coolant

As for the engine specs:

[x] RJM Closed Deck VQ37HR short bare block + added crank / Set of heads

[x] Spec IV IPP block which includes:
- Wiseco or JE Pistons .020 over
- Carillo H Beam Rods
- ARP WMC 3/8" Rod Bolts
- ARP L19 Head Bolts
- Block inspected and cleaned
- Block redecked
- Block Bored and Honed using a Torque Plate
- Rotating assembly balanced
- Crank magnafluxed and the journals micro-polished
- New Moly coated Race Spec main bearings installed
- New Moly coated Nissan OEM rod bearings installed
- Block prepped and assembled
- Cometic Head Gaskets
- Jim Wolf Technology(JWT) Exhaust Cams
- JWT High RPM Valve Spring
- JWT Valve Spring Shim
- JWT Extended Cam Sprocket Bolts
- JWT Cam Sprocket Bolt Washer
- JWT Rear Camshaft Bolt
- JWT Cam Bolt Seal - Copper
- Heads inspected and cleaned
- Heads redecked
- Ported exhaust and intake runners
- 5 angle valve job
- New OEM Valve stem seals installed
- Valve Stem Heights set
- Cold Clearance set for stock cams
- Heads prepped and assembled
- New OEM Oil Pump

Engine will come with Heads bolted to block and torqued to spec