Topgunz - air to air upgrade

TBatt

Just to close up the tach sensor idea, Matthew at AEM responded back with a great idea to get a tach signal for whatever you may need, in my case it is for the data logging AEM boost/afr gauge. MSD makes a sensor that can be used on a injector or coil pack lead. You do NOT have to cut or tap into the wire. It is an inductive sensor that simply clamps over the wire and detects the firing pulse and then re-creates a 12 volt pulse to drive a tach or data logger. Brilliant!

Mine is on the way!

I'm also going to post this over in the DIY section.

https://www.msdperformance.com/produ...ers/parts/8918

Rep points are always welcomed if you find this useful.

__________________
RJM pedal, Hotchkis Sway Bars, FI TDX, FOG Light, Z1 Slotted Drilled rotors, Stillen SC, Quaife ATB, Z1 Oil cooler, AEM Gauge Set, Galeforce gauge mount, Avant Garde M590 Hypersilver w/RE-11, TopgunZ A2A kit., ECUtek tuned by Seb: ROLL TIDE!

StillenZ84

I ended up tapping into my injector lead and the shift light on my innovate motorsports boost/shift light gauge works perfect. Just had to program the shift light in the gauge software to the 1 cylinder option for it function correct.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34