Topgunz - air to air upgrade

StillenZ84

Coming to the final stretches of my tune. Here is a quick clip of a full throttle pull through 1st and 2nd and 3/4 throttle through 3rd and 4th. The road I was on was a little sketchy so I let out a little but it is pulling extremely hard. Note I have M/T ET Street 2's. Hit right under 10 psi 1st and 2nd so not sure what I will hit top of 4th. I have seen 11 psi so far in 3rd just not this pull. Probably wont get an accurate max psi until I hop on the dyno. Seb has my AFR WOT low 12's. Said he might go a little more rich and call it good. My timing is around 22 deg advanced as of now.


https://www.youtube.com/watch?v=Bw-7...ature=youtu.be

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34