Topgunz - air to air upgrade

EVOHUNTER

Hey Stillenz84, hows the flutter at part throttle with that BPV?

__________________

StillenZ84

Flutter isnt bad but the Tial does stay open in every gear till around 2000 rpm light throttle. I occasionally get some flutter around 2200 rpm but not too often. It is definitely loud. haha Turns plenty of heads. Im working this weekend on adding some padding to places that the pipe is hitting the frame because it is tirggering my knock sensor and havent been able to get but a few good log for Seb. I have hit 9 psi at 6000 rpm and the car is a whole other animal with the new kit.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34

BOLIO 671

What psi were u hitting before?

__________________
2013 Nismo Z34 / FI TT #091 / IG: @lilzilla_z34

StillenZ84

I was just under 10 psi at redline before.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34

BOLIO 671

Nice so ur hitting boost earlier @ 9psi @6K rpm.....hopefully those padding did the trick so u can get some clean pulls for ur Data Logs....What are ur intake temps looking like? Are they close to ambient?

__________________
2013 Nismo Z34 / FI TT #091 / IG: @lilzilla_z34

StillenZ84

Yeah hopefully it did the trick. Intake temps are incredibly low compared. It has been mid to high 80s during the day here and my intake temp never gets over 90-95 WOT. I did a few pulls tonight with no knock so Im hoping all goes smooth tomorrow. Was 65 and intake temps didn't go above 75 WOT.

__________________
AtA SC|9 lb pulley|2.85" SC|3.47" Jack|E85|CJM S1-SE|ID1000s|Walboro 485|Zeitronix FF|Stillen CBE|AP Racing|Level 10|F.I. Flex plate|Nismo-S tune|EcuTek RaceRom|Sebz|Speed density|Haltech|3GsCustoms Dual pod a-pillar|Carbon Signal GTR gauges|Fujimura|Built| CP Pistons/Carrillo rods|PortPolishHeads/intakes|928motorsports IG: evanosteenz34

BOLIO 671

Hoping for some more vids soon....

__________________
2013 Nismo Z34 / FI TT #091 / IG: @lilzilla_z34