Stillen Air to Air setup

Originally Posted by EVOHUNTER

The Map sensor conversion has been figured out!

Using our factory MAP sensor on the intake manifold.

This is what I've done - Wire #3 SB - MAF signal. This wire needs to be removed on both MAF sensors. Your map sensor is behind your throttle bodies bolted to your intake manifold.

Your MAP has 3 wires, Ground, Power, and signal. (easily found with your mulit-meter)
Your 2 MAF wires you removed earlier need to be spliced into you signal wire.

Note: this only works with ECUTEK speed density tuning.