Third brake light harness access
 

I have searched and viewed Simoto's thread about removing the third brake light.

My question is the third brake light wiring accessible once the rear hatch trim is removed, or do I have to remove the the compete third brake light to access the wires?

I am wanting to perhaps attach my Kahtec smart stop blinking relay to the third brake light that is in the spoiler, thanks.

There are holes in the deck lid that you "might" be able to reach the wires through.
It's been awhile since I had mine apart, so I'm not sure.

Dude! Haven't you downloaded the FSM yet? Harness routing and wire colors should be in there.

Im MOFO lazy bastid in my old age. I will have to do this as my next task.

I checked it out for the door switch and it just came off with the philips screw meaning nothing fell back into the car B frame.

I still cannot locate the wiring for the third brake stop light. I got to the section showing how to remove it, but I merely wanted to know the colors of wires and if they are accessible without removing the light so that I may connect the kahtec smart switch relay to it.

Pinouts and wire colors are usually near the end of the sections. Right after the wiring diagrams.


Edit: EXL-91 has the wiring diagram. EXL-92 has the connector pinout and colors.

I'll give it a whirl tomorrow.

Sent from my SM-N900T using Tapatalk

I just completed it, did a write up in the DIY section. ta.