HELP window wont roll up

le6tat · 11-28-2009, 06:11 PM

Thanks for the this thread guys. I had the same exact problem from disconnecting the negative battery cable.
Here are the directions again: *indicates re-wording.

If the windows do not close automatically
If the power window automatic function (closing
only) does not operate properly, perform the
following procedure to initialize the power
window system.

1. Push the ignition switch to the ON position.

2. Close the door.

3. Open the window completely by operating
the power window switch.

4. *Push* the power window switch and hold it to
close the window, and then hold the switch
more than 3 seconds after the window is
closed completely.

5. Release the power window switch. Operate
the window by the automatic function to
confirm the initialization is complete.

6. Perform steps 2 through 5 above for other
windows.

If the window will still not close automatically, follow the same procedure but start by closing the window, then keep the button held up for 15 seconds. Repeat for both windows.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Dealer Wont Deal???	DooDooBrown	Nissan 370Z Pricing / Ordering Discussions	42	08-16-2009 09:36 PM
Car wont start	faijia	Nissan 370Z General Discussions	4	06-14-2009 11:37 PM
Here to Rock and Roll	R1jamn	Introduction	4	06-08-2009 09:55 AM
Dealer wont budge - 07 tour/sport/nav/ 40,000	Cjanik	Nissan 370Z Pricing / Ordering Discussions	28	05-30-2009 12:44 AM
Nissan is On a Roll!	SoCal 370Z	Other Vehicles	11	03-03-2009 07:18 PM

11-28-2009, 06:11 PM	#19 (permalink)
le6tat Base Member Join Date: Nov 2009 Location: St. Louis Posts: 7 Drives: 1972 and 2009 Z Rep Power: 16	Thanks for the this thread guys. I had the same exact problem from disconnecting the negative battery cable. Here are the directions again: indicates re-wording. If the windows do not close automatically If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system. 1. Push the ignition switch to the ON position. 2. Close the door. 3. Open the window completely by operating the power window switch. 4. Push* the power window switch and hold it to close the window, and then hold the switch more than 3 seconds after the window is closed completely. 5. Release the power window switch. Operate the window by the automatic function to confirm the initialization is complete. 6. Perform steps 2 through 5 above for other windows. If the window will still not close automatically, follow the same procedure but start by closing the window, then keep the button held up for 15 seconds. Repeat for both windows.