|
could have just come loose. for the side piece open the door and check where it goes behind the door to see if it is loose, there should be a
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
06-06-2014, 02:25 AM
|
#6 (permalink) |
|
A True Z Fanatic
Join Date: Aug 2009
Location: In the D
Posts: 3,732
Drives: v8 74 260z ;)
Rep Power: 7251   |
could have just come loose. for the side piece open the door and check where it goes behind the door to see if it is loose, there should be a 2" long piece of foam body tape holding it to the car and eventually that tape stretches or sometimes gets unstuck. the rear bumper corner may not have been pushed in fully before the bolts were tightened or it was knocked off the clips there. If it pushes in when you press on it you may have to loosen the bolt on the corner of the bumper, push it on more/check to make sure it is in the clip, then tighten the bolt. If it wasn't natural it could have been the previous owner taking a body kit off the car before selling it.
__________________
ANSWER PRICE LIST Answers - - - - - - - - - - - - - - - - $0.75 Answers (requiring thought) - - - - $1.25 Answers (correct) - - - - - - - - - - $12.50 |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Problems starting 2011 | mikerino | Engine & Drivetrain | 6 | 06-03-2014 11:43 AM |
| 370z problems | Joey1010 | Nissan 370Z General Discussions | 60 | 02-27-2014 07:25 AM |
| Problems with 370z | SuperTurbo | Nissan 370Z General Discussions | 7 | 10-09-2012 10:03 AM |
| 370Z gas cap door problems | freddiebear | Exterior & Interior | 42 | 05-15-2010 09:31 AM |
| 2011 Mustang GT cutom wide body | Minicobra1 | Other Vehicles | 16 | 01-19-2010 12:32 AM |
3Likes
Threaded Mode
