EVO-R Nismo front bumper air ducts
 

Just had these made for my Nismo. On the passenger side, had the remove factory windshield fluid tank, replaced with a smaller one. Allow more room for the intake hose.
http://i3.photobucket.com/albums/y96...ps775d0688.jpg
http://i3.photobucket.com/albums/y96...ps4190e3cc.jpg
http://i3.photobucket.com/albums/y96...psd8a81263.jpg
http://i3.photobucket.com/albums/y96...psf04a3441.jpg

What size hose you're using?

I bought an EVO-R foglight, but when I received it, the glue on the top left corner was applied too thick and seeped down, it is very noticeable up close, is there anything you can do for me?

Thanks in advance.

Black screws.


Looks like the NACA ducts. What's the longest section end to end? I don't think they'll fit my 13 because of the LEDs.

PM me you shipping info. I'll sent you another. Let me know smoke or red.

These will fit Nismo only. Working on for stock.

These are custom shapped to fit Nismo bumper only.

I am just using cheap NACA ducts. Heat gun and some rivets make it fit just fine. Wrapped in pho-carbon. No need to custom.

For rusty: 3 inch, reduced to 2 for the Stillen shields.

looking good jay :tup:

:wtf2:

noo???

Damn that looks good...:tup:

I have seen those off of Summit's website. Will see if I can find a link but they are very inexpensive...