From the 2011 manual (can't imagine it's any different):

Attachment 73490

According to page BRC-79 of the 2009 FSM, pin 1 is furthest away from the indexing tab.

i connected the yaw sensor to the toggle switch...everything works fine but, when i close the cap the yaw sensor turns off and when i open the cap the yaw sensor turns off :) it should be the opposite way but i dont know how to do it....anyone has an idea?

Gongrats on getting it working. :tiphat:

It may help to rotate the flip cover 180 degrees. Remove the nut that retains the cover assembly, rotate the cover assembly (you may have to file off an indexing tab on the plate), replace nut.

Do you get any alarms on the dash when the yaw sensor is turned off?

i will try that :) when i turn off the yaw sensor there are two icons appearing, one for the traction control and the other is the esp...when i turn back on i need to restart the engine in order the two icons to disapear...i hope u understand me :)

I understood well enough. Not sure what an "esp" icon is but all I wanted to know is if _something_ came on to let one know that the yaw sensor had been turned off. Thanks for the feedback.

PS: turning the cover may not do anything. Depends on the design of the cover. Most covers I've worked with didn't actuate the switch, just something to keep you from bumping the switch. I have seen a few that would force the switch handle to a certain position and I'm guessing that is what you have.

esp = vdc... and yes that is the type of switch that i have (when i push the cover down it forces the handle in certain position) so you are saying that rotating the switch will do the work?

I don't know that it will fix the problem but it's worth a try - it has worked before.

Rotate just the shield. Loosen/remove the nut that holds the shield assembly on the threaded shaft that the operator (handle you move to turn on/off) goes into, turn the shield assembly 180 degrees, tighten/replace nut.

problem solved :D thanks for the advice....just one more thing left...the light doesnt work...do you know what should i do to make it work?

If there is a third terminal on the switch, it is probably for the LED. If not, I'm not sure.

A wiring diagram would be a big help but you should be able to figure it out with a VOM or diode checker.

Quick question. With the yaw sensor off do you still have to hit the button to turn off traction control is or does that stop working along with the yaw sensor? Can we basically ignore that button from now on?

it works together with the yaw sensor....

Yaw Sensor Switch installed! Everything is working fine except for the led.i couldnt make it work because when i turn the lever up the led turns off, and when i put the lever down it lightens up....but i dont mine, its fine to me without led :)

Also i took pictures of the 3 braces that my father made ( they are not bought, he made them all by himself)....

Ive bought this shift light from raptor performance but i dont know where to put it... :)

The Z already has a shift light in the dash.

HELP - fuse?
 

I was doing this mod and installing an LED rocker switch, when i accidentally touched a wire to the hand brake bolt. I got a nice spark and now I'm having all sorts of issues:

- ABS light on
- VDC light on (even with cut wire reconnected)
- key fob light on
- tpms light on

The car will start fine, but the push button isn't responsive in trying to turn the car off.

Did I fry a bunch of electronics or is there a blown fuse that I'm missing??
:crying::crying::crying: