S-Line Rear Spats
 

So - I bought the S-line rear spats. I live in LA and putting any kind of front lip where I live is simply impossible. I know this from the many other cars I have had. So i'm limited when it comes to exterior until I move to flatter lands with better roads.

But I wanted to finish out the back just a little bit since I have 20MM H&Rs all around. I've installed many body kits - and these are really easy.

Now to the question - directions say to drill two holes into the bumper on each side for two small supports. I'm wondering if this is really necessary considering the amount of 3M tape already on it as well as the additional 3M I would add where those drill marks would be?

Drilling is so permanent - and not certain I want to do that as I'm not 100% sure i will like them.

Anyone installed w/o drilling?

Thanks,