NISMO Titanium Shift Knob installed!!!!

akong51 · 05-17-2011, 12:34 PM

Quote:

Originally Posted by EazyD

Oh no, now I don't know whether I should get the titanium or the CF nismo knobs.......

(best problem ever!)

The good news Eazy...you can't go wrong with either one!

TheGreatOne · 05-17-2011, 01:40 PM

Quote:

Originally Posted by kenchan

note to self... do not piss off TheGreatOne.

hey, remember this... lefty loosey, rigty tighty.

so counter clockwise. if the strap wrench slips it's beyond the torque it can handle. if you sandwich a non-slip like i did, SNAP goes the wrench.

I struggled a bit with the 60's a bit but I was fired up lol

Ok, well at least I was turning it the right way. I'm gonna give it the ol' college try again tonight. I might just post a pic of me in tears if I fail again lol.

kenchan · 05-17-2011, 05:32 PM

Quote:

Originally Posted by TheGreatOne

I struggled a bit with the 60's a bit but I was fired up lol

Ok, well at least I was turning it the right way. I'm gonna give it the ol' college try again tonight. I might just post a pic of me in tears if I fail again lol.

hahahaha.

GL with it, hope you can get it off without damaging the knob.

kenchan · 05-17-2011, 09:37 PM

Picked up my free replacement strap wrench from sears.

will use this one for opening jars or something silly.

FromG2Z · 05-17-2011, 10:07 PM

Quote:

Originally Posted by kenchan

Picked up my free replacement strap wrench from sears.

will use this one for opening jars or something silly.

Still surprised the strap wrench didn't work for you

you're just too strong. Besides, you can use it for oil filters too! and plumbing, etc....

kenchan · 05-17-2011, 10:11 PM

Quote:

Originally Posted by FromG2Z

Still surprised the strap wrench didn't work for you

you're just too strong. Besides, you can use it for oil filters too! and plumbing, etc....

Yah, I can use it around the house.

TheGreatOne · 05-17-2011, 11:35 PM

Success! Black Nismo Knob On!

After almost popping a vein or two

So putting the duct tape on the knob worked (Thanks FromG2Z

) but not how I imagined. Kenchan thanks also!

Wrapped the knob up in duct tape but it didn't really budge. Took the tape off and now the knob was sticky. Used one of my Terry cloths on the knob..strap wrench and OMG....it started to turn.

Camera is kinda crappy and too much flash, it looks much better in person...matches well in the interior. The feel is soooo different, but I think I like it...will drive to work tomorrow.

TWYNBYZ · 05-18-2011, 01:15 AM

Same here. Was able to finally loosen the stock shifter knob and replace it with my Nismo carbon fiber shifter. I must say that it definitely feels better than the stock shift knob.

bflosabre91 · 05-18-2011, 09:20 AM

my black aluminum came in yesterday. I tried and failed haha. The strap wrench just kept slipping. Ill have to try the duct tape trick to see if i can get a better grip. It looks great @thegreatone. Can't wait to be able to get mine on.

FromG2Z · 05-18-2011, 11:24 AM

Quote:

Originally Posted by TheGreatOne

Success! Black Nismo Knob On!

After almost popping a vein or two

So putting the duct tape on the knob worked (Thanks FromG2Z

) but not how I imagined. Kenchan thanks also!

Wrapped the knob up in duct tape but it didn't really budge. Took the tape off and now the knob was sticky. Used one of my Terry cloths on the knob..strap wrench and OMG....it started to turn.

Camera is kinda crappy and too much flash, it looks much better in person...matches well in the interior. The feel is soooo different, but I think I like it...will drive to work tomorrow.

LOOKS great man! I think any of the Nismo knobs look great with the Z interior, and the shape/feel of it is the biggest plus for me.

So for you and others that I have helped out.... I would appreciate some REP POINTS please!!!!!!

p.s. so the stock knob is in perfect condition?

TheGreatOne · 05-18-2011, 11:30 AM

Quote:

Originally Posted by FromG2Z

p.s. so the stock knob is in perfect condition?

Rep points added!!

Actually some of the rubber to the front slid over exposing the metal below, but stock knob is pretty much intact minus that little blemish

Ya, it feels really good and responsive. I don't know if it makes sense, but the feel seems to carry down to the transmission more (to me) where with the stock knob, I just feel like I was moving the knob around.

FromG2Z · 05-18-2011, 11:36 AM

Quote:

Originally Posted by TheGreatOne

Rep points added!!

Actually some of the rubber to the front slid over exposing the metal below, but stock knob is pretty much intact minus that little blemish

Ya, it feels really good and responsive. I don't know if it makes sense, but the feel seems to carry down to the transmission more (to me) where with the stock knob, I just feel like I was moving the knob around.

Thanks buddy!

YES!!! You are SPOT on with your analysis of the new knob. For one, it actually is a little shorter in height, which results in shorter throws. But the biggest advantage I think is in "feel" during gear rowing... it seems to snick-snick better, plus you can really feel like your more in-tune with the transmission... like you're "one".... more sporty, better feeling, better engagement. I think it's both mental and physical, but there are some definite physical changes that are there.... I love it.

kenchan · 05-18-2011, 11:51 AM

thegreatone- dang, your interior looks great! nice job~

i am the only one that failed.

nynhex · 05-19-2011, 02:52 PM

Looks like I'm also in for a fail.. Ordered my TI shift knob today from TheNismoShop. Thanks for the referall Kenchan!

kenchan · 05-19-2011, 04:28 PM

Quote:

Originally Posted by nynhex

Looks like I'm also in for a fail.. Ordered my TI shift knob today from TheNismoShop. Thanks for the referall Kenchan!

sounds great!

looking at thegreatone's strap wrench, he used the larger red one so get that one + cover the knob up with a terry cloth before strapping the thing.

05-17-2011, 11:35 PM	#82 (permalink)
TheGreatOne A True Z Fanatic Join Date: Jan 2011 Location: Montreal, Canada Age: 46 Posts: 1,980 Drives: E60 BMW M5 Rep Power: 21	Success! Black Nismo Knob On! After almost popping a vein or two So putting the duct tape on the knob worked (Thanks FromG2Z ) but not how I imagined. Kenchan thanks also! Wrapped the knob up in duct tape but it didn't really budge. Took the tape off and now the knob was sticky. Used one of my Terry cloths on the knob..strap wrench and OMG....it started to turn. Camera is kinda crappy and too much flash, it looks much better in person...matches well in the interior. The feel is soooo different, but I think I like it...will drive to work tomorrow. __________________ 2017 SUBARU STI 2008 E60 M5 - SOLD 2010 40th Anniversary 370Z - SOLD (and missing her)

05-18-2011, 09:20 AM	#84 (permalink)
bflosabre91 Base Member Join Date: Mar 2011 Location: na Posts: 114 Drives: car Rep Power: 14	my black aluminum came in yesterday. I tried and failed haha. The strap wrench just kept slipping. Ill have to try the duct tape trick to see if i can get a better grip. It looks great @thegreatone. Can't wait to be able to get mine on. __________________ Zzzzzzzzz

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Nismo Titanium Shift Knob Open-O Design Installed	karotZ	40th Anniversary 370Z	22	03-04-2011 04:58 PM
FS: NISMO titanium shift knob	VancouverZ34	Parts for sale (Private Classifieds)	5	02-26-2011 09:43 AM
NISMO GT Titanium shift knob!	corner3garage	Body Interior/Exterior	4	01-16-2010 02:52 AM

05-17-2011, 09:37 PM	#79 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141521	Picked up my free replacement strap wrench from sears. will use this one for opening jars or something silly.

05-18-2011, 01:15 AM	#83 (permalink)
TWYNBYZ Base Member Join Date: Jan 2011 Location: S. Cali Posts: 229 Drives: 2013 Pearl White GTR Rep Power: 14	Same here. Was able to finally loosen the stock shifter knob and replace it with my Nismo carbon fiber shifter. I must say that it definitely feels better than the stock shift knob.

05-18-2011, 11:51 AM	#88 (permalink)
kenchan A True Z Fanatic Join Date: Aug 2009 Location: N/A Posts: 76,801 Drives: N/A Rep Power: 141521	thegreatone- dang, your interior looks great! nice job~ i am the only one that failed.

05-19-2011, 02:52 PM	#89 (permalink)
nynhex Base Member Join Date: Apr 2011 Location: Houston Posts: 247 Drives: 370z Rep Power: 371	Looks like I'm also in for a fail.. Ordered my TI shift knob today from TheNismoShop. Thanks for the referall Kenchan!