Open Door / Window Roll-down Issue

eastwest2300

You're likely to see different results from doing the reset, but keep doing it until you get the result you're looking for.. thats what happened to me.

__________________
Infiniti QX70 & Toyota Supra 3.0 Premium

Zbrah

I think so. My window doesn't auto roll down when I open the door like it usually does, it used to go down like half an inch and closes back up when the door is shut, but now it's no longer doing that. It started a while back after I had tint put on, I just haven't had time to look into it.

__________________

Mozen

In my case the windows occasionally would not roll us after I open the door then close it. If j opened the door again and closed it it would be fine. Reset procedure didn't do anything so eventually I just bought a new sensor/switch for the door and it solved it.

Sent from my SM-G900F using Tapatalk

__________________
PW 370z | AEM | MISHIMOTO | ARK PERFORMANCE | WHITELINE | NISMO | STILLEN | FORGESTAR | BC RACING | AMS | NON STOP TUNING | CARBONETICS LSD | 4 Point DOM 1.75" SCCA Spec Roll Bar + Harness Bar
CHECK OUT MY BUILD THREAD HERE

BoneZ

Is that the pin switch in the jam? Is the sensor/switch that one part?

__________________

Mozen

I replaced the part the door closes on and that reads closed or open.

Sent from my SM-G900F using Tapatalk

__________________
PW 370z | AEM | MISHIMOTO | ARK PERFORMANCE | WHITELINE | NISMO | STILLEN | FORGESTAR | BC RACING | AMS | NON STOP TUNING | CARBONETICS LSD | 4 Point DOM 1.75" SCCA Spec Roll Bar + Harness Bar
CHECK OUT MY BUILD THREAD HERE

BoneZ

__________________

Mozen

Yep

Sent from my SM-G900F using Tapatalk

__________________
PW 370z | AEM | MISHIMOTO | ARK PERFORMANCE | WHITELINE | NISMO | STILLEN | FORGESTAR | BC RACING | AMS | NON STOP TUNING | CARBONETICS LSD | 4 Point DOM 1.75" SCCA Spec Roll Bar + Harness Bar
CHECK OUT MY BUILD THREAD HERE

Zbrah

Can please you show me which screw to adjust?

__________________

scottIN

Pretty sure it's the screw under the rubber piece shown above. If I remember correctly, he pushed in the sensor and then tightened down the screw to lock it up. Then obviously loosen the screw to unlock.

Zbrah

Okay, got it. I saw that rubber nipple looking thing while looking for the screw yesterday but I didn't know that was it. I'll give it a try later. Thanks!!

__________________

Zbrah

Fixed! I tightened the screw holding the sensor switch while pressing it it down. All is good now, window is functioning like before!

Thanks again scottIn!

__________________

BoneZ

Wonder if mine in loose.

__________________

Zbrah

Apparently the tint guy loosened the screw to keep the window from automatically moving down because you are not supposed to roll the window down for a couple days after new tints are installed, he forgot to mention to me how to undo it

__________________

BoneZ

Well now this morning the passenger side window cracked like it's suppose to, but then didn't go back up. After opening and closing again, it went back. Not digging this.

__________________

Davey

So, what ever happened with this?

I'm pretty sure mine did this yesterday again, which would make twice now.

Here's what I think is happening

1. Open door, window doesn't go down like it's supposed to
2. Close door, and don't hear the "zppp" noise or see the window go up
3. Go "wtf" and open door again, and the window goes down.

I know the window probably doesn't seal right without the window being down & going back up after you shut the door, but I'm concerned there is an interference issue between the top of the window and the car body, is that the case? I hope not. I don't see any damage.

I pressed and released the little switch in the door jamb that senses whether the door is closed about 20 times and the window went up and down as expected.