Seat belt removal and Install

zmanelite

I am no way liable for anyone messing anything up and only doing this as the process i took to change my belts


OK so you will need a 14mm socket and a 10mm socket , Phillips screw driver plus a pry tool

Total time i would say 1.5 hr to 2 hr depending on skill

If you have removed rear speakers you have already done about 3/4 of the work already

Here is the start point


Remove all 4 pins on both sides




After you can pop the rear section off




Remove carpet and floor , once you do that you can pop these pieces off






Remove these 10mm bolts located in these holes 1per side of car




Now move to the front and remove these carpet panels , they are a bitch but will pop up




Remove the 4 clips that are toward the front of the car 2 per side





Remove 2 screws with a Phillips screw driver 1 per side





Now take off the panels and the plastic on the strut bar slides out




Remove Door Kick panels they just pry up and side panels where speakers go




Now you can wiggle this part out and remove , it slides backwards and when putting back together this should be the first part installed




These are a little hard to take out and i take no responsibility of damage to the plug or belts
I removed them by prying with a flat head , to reinstall them on new belts they are also a bitch and need a little force and wiggle at the same time




Now remove the top 10mm



And bottom 14mm




Get the cover off the top and remove the 14mm also




Last 14mm is at the bottom




Now all you have to do is remove belts and replace with new ones , reverse the process and you are good to go

__________________
Instagram @zmanscm