TRUE OF FALSE Power Loss After Intake and Exhaust Setup

Bshields22

Hey guys,

I have been seeing multiple people say different things about the end result of an intake and exhaust mod. Thought I would try and get to the bottom line

1. Does a Stillen (or any other good brand name) Intake and Exhaust cause a power loss? I would use the qtr mile and/or 0-60 to crosscheck the "claimed" power gain or loss.

2. Since I hear more "powerloss" stories then gain stories, say there is a power loss, what needs to be tuned for the power loss to surpass the stock performance? Typical costs and success rate?

Also how does that tune effect the rest of the car? Would it cause other issues down the road since other components in the car are not built around the new calculation?

Thanks for all the help!!

axmea?

Assuming proper installation and proven parts, there should be gains. What forum are you getting this information from?

__________________

DEpointfive0

Yeah, power loss across the board with any breather mod. Don't pay attention to those pesky dyno sheets

__________________
Do YOU want to know what/where I got my username from?

1st

I hear the same thing (power loss) loss of low end torq with the long tubes….power loss with short ram due to heat soak. Its either oem, z1 tubes, or g3’s. Honestly F*** what you heard my Z pulls with long tubes/catback….HARD.

jaytirbhaw

You won't lose power compared to stock if you're installing the right parts.


1. You may lose a small amount of torque on the low end but not enough to notice, after a *GOOD tune you will gain all your losses back plus some.

2.Success rate of gaining power after a tune is pretty much 100% , *as long as you're being tuned by a tuner who knows what they are doing*.

The tune makes the difference but even without one, there are many dynographs floating around showing proven gains.

brutusvk

I believe tuning is the key regardless. Night and day IMO.

jwick

FALSE. You could lose tq based on decreased back pressure but you would pick up HP. I picked up almost 40whp with Stillen G3's/CBE and Berk HFCs. Another 15whp with the tune. Went from 262whp stock to 314whp full bolt-on tuned.

__________________
'10 G37T 6MT Graphite/Graphite - BP - G37T Build

juld0zer

the other thing to consider is breathing mods alter the orgasm point. where you used to feel the car pick up, it now happens generally later with such mods. i lost a noticeable amount of low end torque going from an Exoticspeed mid/Y pipe with stock rear muffler to the Invidia full catback

jwick

The tune fixes that

__________________
'10 G37T 6MT Graphite/Graphite - BP - G37T Build

juld0zer

on my to-do list

ghotnit

When I did all the breathing mods on my car (intake, test pipes and exhaust) the ECU was not happy. It was not able to cope with the changes and fluctuated from lean to rich which caused a power loss and a crappy running car. IMHO, when you modify the breathing, especially the intake, you should (read "need to") tune the car. That is the only way to get the benefits from the money you spent. If you are not planning to tune the car to match the mods, save your money. For the exhaust, if you want to change the sound, get an axle-back system.

__________________
'14 Nismo AAM 3" TD / AAM Test pipes / AAM CAI / Lowered on Swift / Synolimit Ported TB, upper and lower manifold /DW 1000cc injectors and 340 pump / ECUtek tuned by Hal @ Dynosty / 331whp/268wtq on E85

Zoren 370

Honda Civic Ricer Forum?

Zoren 370

I don't know with you guys but I do have all the breather mods intake, full exhaust, HfC etc. etc.

No tune..ECU smart enough to re-learn and my car runs like with a Ferrari engine. And I smoke pot!

Driftomodachi

If you change out the cats the car will run leaner. Change the exhaust and intake AFTER taking out the cats it will be even WORSE...without a TUNE.

Swap out the cats LAST and get a tune and it will be fine

__________________
2010 40th Anniversary ll GT-R start button ll GT-R map lenses ll Plastidipped fangs and rear valence ll OEM foglight & switch ll Motordyne E370 Cat back ll Motordyne ART Pipes ll Takeda aFe Attack CAI ll Sprint Booster ll Z1 34 row Setrab oil cooler ll Z1 Motorsports M-Spec Shift Knob

jwick

Same boat before I went turbo

You guys do know you need to reset the ECU after the mods and maybe perform the idle relearn


Yo pass it left homie

__________________
'10 G37T 6MT Graphite/Graphite - BP - G37T Build