Opinions on Clutch flush/bleeding

[Akurei]

Tomorrow i will be using this item

Brake Bleeder and Vacuum Pump Kit

So basically i will attach this to the bleed fitting on the transmission housing, which is the CSC bleeder (obviously opeing the bleeder). It creates a vaccum, and i will be holding a pressure between 10-15 psi using motul rbf600 to top off the reservoir until brand new fluid comes out.

Has anyone used this set up? I used brake bleeders that attach to the master cylinder, but this will be the first time using this device, none the less on a clutch hydraulic system.

Is there anything i should know etc. Otherwise i believe this should work flawlessly as long as i keep the reservoir full.