![]() |
IMO, the only difficult part about doing clutch work is putting the transmission back on the car. Working with the pressure plate / clutch / flywheel should be easy. I
|
![]() |
|
LinkBack | Thread Tools | Display Modes |
|
![]() |
#1 (permalink) |
Track Member
![]() Join Date: May 2014
Location: Florida
Posts: 877
Drives: Magma Red 370z T+S
Rep Power: 21 ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() ![]() |
![]()
IMO, the only difficult part about doing clutch work is putting the transmission back on the car. Working with the pressure plate / clutch / flywheel should be easy.
I don't have a Zspeed unit, so I am not sure how much assembly is required before mounting it on the trans, but perhaps one of the fittings is not properly secured to the unit and it is leaking. Here is a link on how to bleed the clutch: REQUEST: DIY Clutch Fluid bleed/swap/replacement. I was actually able to do it myself, by rotating between the master cylinder, to monitor fluid levels, the clutch pedal, to pump it several times, and the bleed valve to release the air, it probably took 30 minutes, not including the time to put the car on jack stands.
__________________
Competition Clutch|Fast Intentions|Maxbore|NST|Setrab|Stillen|Tomei|Uprev| Z1 Avant Garde|SPC|Stance|Whiteline Aerojacket|Seibon|Tanabe|TRS|TWM |
![]() |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
problem with the clutch | swish008 | Engine & Drivetrain | 16 | 06-04-2013 07:48 PM |
Clutch Problem??? | niznizbobo | Engine & Drivetrain | 11 | 03-24-2012 09:07 PM |
?370z clutch problem | big-col | Nissan 370Z General Discussions | 7 | 06-02-2010 12:56 PM |
Clutch Problem. | Gunzero | Nissan 370Z General Discussions | 11 | 03-09-2010 07:01 PM |