|
Check to make sure no harness's are melted. Transmission harness is somewhat close to all that exhaust side piping...I think haven't seen a BP kit in person...but I melted mine
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
04-24-2014, 10:53 AM
|
#11 (permalink) |
|
A True Z Fanatic
 
Join Date: Feb 2012
Location: Pennsylvania
Posts: 2,029
Drives: 11' 370z Sprt M6
Rep Power: 20   |
Check to make sure no harness's are melted. Transmission harness is somewhat close to all that exhaust side piping...I think haven't seen a BP kit in person...but I melted mine into a solid mass on the dyno. Anyways make sure nothing is melted...if the transmission position sensors wiring grounds out or anything the car will crank but never start. But with that you should have codes...But my guess is electrical/sensor issue. Check fuses as well.
__________________
|445whp398tq| |BW S259 Turbo|3" Downpipe\Exhaust|ID1000|AeroMotive|Tial|EcuTek|BC BR|S0-4|MaffFab| MKGs-Single-Turbo |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 370z wont start no power . Where to start | acracing118 | Exterior & Interior | 6 | 01-05-2013 06:37 PM |
| Car will start sometimes and not start, need advice | aragona7 | Nissan 370Z General Discussions | 11 | 03-08-2012 10:23 PM |
| If you had to start all over.... | saiko71 | Forced Induction | 31 | 03-27-2011 08:56 PM |
| cold start/push start | chops | Nissan 370Z General Discussions | 21 | 02-14-2011 03:40 AM |
| HELP: Car won't start! | tjlazer | Engine & Drivetrain | 41 | 04-06-2010 02:21 PM |
9Likes
Threaded Mode
