|
Installed G3's on saturday and drove approximately 250miles without any problem and my engine pulls a P2a00. I know all of the vaccum lines have been properly attached to inake
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
02-07-2013, 02:45 AM
|
#1 (permalink) |
|
A True Z Fanatic
Join Date: Aug 2011
Location: palmdale, ca
Posts: 1,299
Drives: 2010 nissan 370z
Rep Power: 16  |
SES after G3
Installed G3's on saturday and drove approximately 250miles without any problem and my engine pulls a P2a00. I know all of the vaccum lines have been properly attached to inake tubes. Anyone every come up with a solution to this code or have a smilar problem? I read the 15 threads that concerned this code and no answer was seen. Any helpful pointers would be greatly appreciated.
__________________
https://www.youtube.com/watch?v=RtvG...data_playerARK HFC'S-ARK Grip-Stillen G3-M370-UPREV-Kinetix upper control arm-WC Latheworks-Stage2 Bad@$$ Driver(318whp/268tq)- |
|
|
| Bookmarks |
|
|
6Likes
Threaded Mode
