SES after G3

roy'sz

ok...UPDATE. I checked the maf sensors and there doesn't appear to be any oil on them. Does one know how to clean them or the procedure for doing so? Also checked the crankcase vent hoses and they are all properly seated and clamped. Throttle hoses are properly mounted as well. I had the HFC's on for close to 2k miles and only had the common codes with that. I installed the bung extensions this past weekend with the G3's and know that I did tigthen them down really well so to the point where it popped a little bit (thats how I knew they were tight) and installed the 02 sensors with them. Please help or give me some guidance on what it could also possibly be? I read that the G3's lean out fuel mix, is this the common code behind installing the G3's?

__________________
https://www.youtube.com/watch?v=RtvG...data_playerARK HFC'S-ARK Grip-Stillen G3-M370-UPREV-Kinetix upper control arm-WC Latheworks-Stage2 Bad@$$ Driver(318whp/268tq)-