13 Months later, it happened AGAIN!
 

And the dealer asked me how I know its was the cylinder..lol

http://www.the370z.com/engine-drivet...-went-out.html

...Should be flawless being a new Nissan...

^ buahahaha yeah im disappointed in my purchase of the nissan Z because i expected so much more, i expected it be a great car with stronger components to show that its worth 40k but oh well i have 5 years till its paid, 9k miles transmission is being replaced later this week... lame 6th crapped out

was it a manual or auto and how did it fail ?

Sorry to hear SoCalZ!
This has happened to me once already. Crossing my fingers that it won't happen again.

sorry to hear

that can't be pure bad luck... i wonder if there is something wrong with the clutch? like if the pressure plate was made incorrectly and is too hard to push causing the slave cylinder to wear out prematurely or something?

Plastic slave with crappy seal design, Been this way since 07, Slave design has never changed. It's just luck of the draw whether one last or not.
Have personally seen 5 OEM Slaves blow in a 5,000 mile span, Granted this was with an aftermarket clutch and it is always seal failure, if the seal happens to last, the release bearing that is held on with a plastic sleeve will eventually break off the end of the slave causing complete failure.

Nissan, or the shop that built the car, blew a brand new (or 2) slaves out during the Enthusiast 370Z build when bleeding the clutch and ended up with our kit so they could get the car to ZDays for the show.

We have more than a few cars with over 20,000 miles now on our HD slave kit even with heavy ACT, OS giken ect clutches and basically ZERO failures.

not knowing the guy i, but having the exact same problem i'm going to venture a guess and say it was a manual with a 6th gear synchro failure. pretty common on these trannys. mine went out about a month ago

CSCs are plastic crap

Yep.