05-30-2019, 01:47 AM
|
#1 (permalink)
|
|
Base Member
Join Date: Dec 2013
Location: United Kingdom
Posts: 244
Drives: 2013 370Z-TT GT Edt
Rep Power: 3367
|
Quote:
Originally Posted by Bandit_Kaine
Has anyone had an issue when installing this pedal where the clutch does not engage?
I just finished install of v3.3 and followed all the instructions (except the clevis end upgrade, i left the stock one on) and when i put the car into first gear and release the clutch it seemed to be engaging fine.
I went out for a quick test drive, however it may not have been fully engaging, as it was slipping soon after, about 0.5 miles into my drive the clutch is not engaging at all, i put car in 1st gear and fully release clutch and car won't roll.
I adjusted the upper brown switch to such a way that it would be pressed just slightly as the pedal was fully released.
is there any adjustment for clutch engagement i should be looking at?
|
You may have to adjust your master cylinder rod lenght. Basically the position at which your clevis end is held in place with the nut
Best wishes
Sent from my iPhone using Tapatalk
__________________
501 BHP, 590 Nm (422 rwhp) AAM TT+I/Plenum|CJM S1 FRS|C/Clutch Stage 2|RJM CMC|ZSpeed CSC|Z1 Oil cooler|Motordyne Turbo ShockWave)))|Torqen Coilovers|Stanceparts AirCups|Amuse bodykit|GReddy|AEM|ONEighty|Mishimoto|STILLEN|Eibach|SPL|B&M|Radium|EcuTek|BC Forged RS45
|
|
|
Similar Threads
107Likes
Hybrid Mode
