05-27-2012, 06:20 PM
|
#4 (permalink)
|
|
Base Member
Join Date: Mar 2011
Location: VA
Posts: 16
Drives: 2010 370Z BC 7AT
Rep Power: 15
|
Quote:
Originally Posted by MACSIMIZER
I had a failty sandwich plate housing with mine, bad casting, it was leaking through 2 tiny little holes in the casting but it was on the opposite side where yours is leaking. Try getting a small lighted inspection mirror in there to see where it is leaking from. Ended up replacing my plate with a new one. Good luck.
|
I was feeling all around it with my hands and a clean rag.
Quote:
Originally Posted by Triple's
That looks like its either loose or to tight
Reinstall it and don't over tighten the fitting that bolts the plate to the block, And make sure both surfaces are clean.
I know its bloody mess!
I had the same issue once.
I just reinstalled and tightend just enough that it was snug and have not had any issues since.
|
The fitting that screws directly into the sandwich plate moves when i'm tightening the lines unto it...i guess i can use another wrench to hold the fitting in place so it doesn't overtighten.
|
|
|
Similar Threads
4Likes
Threaded Mode
