|
will take some this weekend. I noticed that the pressure side is leaking on my cooler. When you did the install did you use any pipe sealant for the cooler
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
10-11-2011, 08:43 PM
|
#1 (permalink) |
|
A True Z Fanatic
Join Date: Aug 2011
Location: palmdale, ca
Posts: 1,299
Drives: 2010 nissan 370z
Rep Power: 16  |
will take some this weekend. I noticed that the pressure side is leaking on my cooler. When you did the install did you use any pipe sealant for the cooler side of the male fitting? I know its a tapered fit on the an-10 but what about the male nipple to the female cooler part? It weeps just a little and I set up the hoses so it would "tighten" as far as the angle. Kinda scratching my head. Not sure if it is residue from when I checked and moved it around the other day.
|
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Can a Mocal Thermostatic plate fail ? For my oil cooler? | chuckd05 | Engine & Drivetrain | 14 | 02-11-2019 11:19 AM |
| Check out my DIY Oil Cooler Block Off Plate Thread | SPOHN | Nissan 370Z General Discussions | 10 | 03-14-2011 08:57 PM |
| Oil Cooler Thermostatic Sandwich Plate Conversion Kit? | Nismo221 | Engine & Drivetrain | 5 | 09-07-2010 12:44 PM |
| Oil Cooler Sanwich plate noise | The Arp | Engine & Drivetrain | 9 | 05-03-2010 04:18 PM |
Hybrid Mode
