clutch pedal issues?

xgrudgex

Just today I had some issues when shifting at highway speeds, just wanted to see if anyone else had any of the same issues?
Well basically I was driving in 5th gear thru slow traffic... about 15 minutes(I'm in cali lol)
And when speed picked up I went to shift but I had about 6 inches of dead pedal and the last inch I had pressure.... wtf!?
So I popped it in neutral and tried hitting the clutch repeatedly to maybe build the pressure up but no go, pulled over, after about a minute of ddriving thru the streets it came back!
So fluids are good, belts tight, the only thing I'm low on is window piss so I'm confues:/ any ideas or anyone else have a similar issue?

kenchan

Why were you in 5th? Should be 3rd and lowerfor slow traffic... creeping traffic I only use 1st.

xgrudgex

Always someone on here trying to make someone look stupid... I was actualy coasting in "slower" than what highway speed... not 35 mph it was speed up and slow down from 45-60 which I feel 5th gear was appropriate. But thanks for trying to explain how I should drive my car

As for the issue it was the brake booster.... so they say which makes sense since all fluids were where they should be, I dont think it was a leak just more of a malfunction, either way sucks for me since I will be paying out of pocket for it since I am past the 35k mile coverage.... lameeeee

Pharmacist

hold on, why would the brake booster affect the clutch? they are not connected in any way. if the brake booster failed, it will be your brake pedal that will feel different, and it will be harder, not softer.

__________________
2009 370z Sport Touring/Nismo shift Knob/Z1 motorsports 34 row oil cooler

IDZRVIT

Like Pharmacist noted, please explain the relationship of the brake booster with all the fluids. What exactly did the dealer tell you?

__________________
"America.... still builds rockets!"
Vette: 355 cid, 400 rwhp
'13 CTS-V Coupe: 6.2L LSA, 556HP

xgrudgex

I guess you didnt get the sarcasm in the "so they say".... I am assuming it was an issue witht he slave cylinder but not completely sure.
I am using my overpriced, crappy teaching from UTI and my few years of wrenching to diagnose what the service manager poorly explained so dont put me on blast if you think im wrong;/ but long story short I just bent over and took it dry.
Didnt feel like being that know it all customer (use to be a tech and hated that!!!!) and just paid the dealer.... missed my girl too much to care about arguing.
I dont have the reciept on me but it did look sketchy with a "replacement item" for part description that was 110 bucks and an efing 300.00 dollars worth of labor. I wont be taking my car to my local dealer anymore thats for sure!

*update* I have noticed in the past week that my pedal is starting to get softer again and stick on the release... will let you guys know if I have the same issue again.

Zat_Zuma

It sounds like your clutch fluid need replacing.
The soft pedal condition can happen if you have air in the system or if the fluid is past it's boiling point and that can cause the symptoms you've described. Sometimes if the clutch fluid has absorbed water or seen too much heat once too often, the boiling point of the fluid drops dramatically and will start to vaporize in the line and lose the hydraulic properties of the fluids. The best recourse is to flush and replace the clutch fluid with a quality brake fluid with a higher boiling point. Clutch fluid is the same stuff as brake fluid, if you were wondering.

Hope that helps

__________________
[B]2009 & 2017 370Z Touring Sport Autos SOLD

jaedub

you sure your clutch fluid didnt leak?

mcwoowoo

I just got the same issue, clutch paddle lost pressure. I started to notice the clutch felt very soft for the first half and the engagement point felt like it had shifted to the bottom. Yesterday, the while driving on freeway and coming to traffic stop the clutch paddle got stuck to the floor when I down-shifted. The problem seemed very apparent on freeway, and less for local driving. I when to the dealership and 2 hours later they said they have to replace the Master and Slave clutch cylinders per Nissan Tech Support.

Israeli_Z

I've had the same thing since day one. I always thought it was normal...my clutch only engages 2 inches from the top and the rest doesn't do anything. I don't even depress my clutch all the way because it seems like there is no point. Now I'm paranoid!!!

__________________
2010 Pearl White Sport 6M/T: Philips~ Amuse~Meisterschaft~Stillen~Polk~JL~Alpine~Wicked C.A.S.~

RockStarKick

Check this thread out clutch high engagement point

__________________
2013 Mustang GT, 6M, Track Pack & Leather Recaros
2011 Pearl White 6M /Sport Pkg - SOLD

Israeli_Z

Thanks. I'll bookmark that page but I actually don't mind the high engagement...just wanted to make sure it wasn't affecting or damaging anything.

__________________
2010 Pearl White Sport 6M/T: Philips~ Amuse~Meisterschaft~Stillen~Polk~JL~Alpine~Wicked C.A.S.~

Endgame

If I were to go through the process and lower my engagement point, if I had experined the above issue xgrudgex experiences, do I risk damage to the clutch? would it not fully disengage?

RockStarKick

I would think not.. As long as you make sure that the clutch is fully engaging/disengaging.

I personally like the engagement point of my clutch, it engages about 40% from the floor.

__________________
2013 Mustang GT, 6M, Track Pack & Leather Recaros
2011 Pearl White 6M /Sport Pkg - SOLD

Endgame

Thanks. My engagement point is a little on the high side; I just want to lower it some, maybe 1 turn....