AH! I like the new manual. :P When I installed mine I routed the lines more like Modshack's DIY because I couldn't figure out how in the world I was supposed to run the lines per the instructions.

What would you charge someone with an older version of the kit for the upper bracket for the cooler core?

PM sent!

I just had my 34 row cooler installed. Only problem he had was with my Injen CAI. Adjustment made and all is good! Noticing 20+ degree difference right off! :tup:

Is it possible to install the lines without having to drill into the plastics?

I have the 34 row cooler on a Nismo. If you look on page 2 of my journal. There are some pictures. I ran my hoses over the top of the white foam bumper piece, and around the corner down to the filter.

Thanks for this DIY! Reading it and the instructions together before working on it helped a lot. Took me 2.5 hrs in no rush. 25 row you do need to take the bash bar off to drill the top bracket hole. It’s too much of an angle.

Now start covering rows if you're only street driven. I'm on a 25 row and run 18 in S. Florida I won't even see temps over 200*.

I routed mine up through the air intake port then along the front crash bar. As I have injen intakes the route shown doesn’t really work.