Originally Posted by Rusty Mobile 1 0w-40 Euro blend. Has everything you need. It’s been a minute, this is the only mobile 1 oil that’s actually a true synthetic right?
|
|
LinkBack | Thread Tools | Display Modes |
05-13-2021, 11:16 PM | #16 (permalink) |
A True Z Fanatic
Join Date: Feb 2009
Location: FL
Posts: 4,776
Drives: Baby Shark
Rep Power: 701615 |
It’s been a minute, this is the only mobile 1 oil that’s actually a true synthetic right? Also stock GTR fill as well. If so, that’s what we used for a total of 6 years and shitloads of track days (plus 34 row oil cooler). That oil if it’s the one we used runs “thin” for a 40 weight so it’s fine,a very good oil choice that is available everywhere like Wally World.
|
05-14-2021, 12:04 AM | #17 (permalink) | |
Ronin Samurai - Assassin
Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 68
Posts: 35,187
Drives: 2011 Nismo GM 6M
Rep Power: 2684437 |
Quote:
__________________
浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html |
|
05-14-2021, 06:46 AM | #18 (permalink) |
A True Z Fanatic
Join Date: Mar 2011
Location: NJ
Posts: 2,400
Drives: slowly
Rep Power: 40569 |
Running one grade higher or lower in reality won't hurt anything. The _W number will make the most noticeable difference for cold weather.
Oil is designed to be at around 212F or 100C regularly. If you run a 40grade oil instead of a 30grade the temps need to be at around 239F or 115C regularly to achieve the same viscosity. Question is why would you want to run at higher temps regularly, heat makes everything worse in an engine. I did switch to 5W-40 right before track events and change it out after.
__________________
GTR TT 493Whp/431lbft, Ecutek, Southbend 6puck,Quaife, RPM RollBar 4Point, R888R, JRZ RSPro F(10R/10C) R(10R/6C) 1000f500r inlbs+150inlbs Tender, SPL everywhere.Full Specs |
05-14-2021, 11:20 AM | #20 (permalink) |
Ronin Samurai - Assassin
Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 68
Posts: 35,187
Drives: 2011 Nismo GM 6M
Rep Power: 2684437 |
fify
__________________
浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html |
05-14-2021, 07:44 PM | #21 (permalink) | |
Base Member
Join Date: Jan 2018
Location: Sydney, Australia
Posts: 61
Drives: 2018 370Z KAD 6MT
Rep Power: 3766 |
Quote:
Look at 2011Nismo's graph a couple of posts up. The VVEL system has to work with 5W30 oil that has a viscosity of 50 at 40 degrees C. At 0 degrees C the viscosity will be 100+ and the VVEL still has to function (at least under low engine stress, to idle the car and drive gently until oil temperature improves). I could fill my car with 5W30 and flog it as soon as the oil temp needle has started to come up, at 80C 5W30 oil has the same viscosity as 5W40 does at 100C. There is some truth in "thicker oil provides more protection at high temperature" and "thinner oil flows better so it removes heat well" and so on. But unless you are building a 1000hp beast or spend most of your time above 5000RPM it matters a lot less than you think. I used to spend a good half hour staring at the oil aisle before making a decision but the fact my engine didn't blow up doesn't mean fussing over it that much was justified |
|
05-15-2021, 12:10 AM | #22 (permalink) |
A True Z Fanatic
Join Date: Jun 2011
Location: Madison, WI
Posts: 1,397
Drives: 2009 370Z
Rep Power: 16804 |
Swapped to M1 0W40 on the Z a couple years ago and Blackstone reports have been great.
40k miles or so but heavy track use. It should be a fairly safe swap from 5W30 to 0W40 for most cars.
__________________
@stupidtoycars | My track vids 09 7AT|MCS 2WNR|Topgunz Rotrex|Ecutek (Eugene)|Maxxis RC1|Titan-7 TS-5|OSG LSD|Rear Mount Derale Oil Cooler (WIP)+25 Trans Cooler|Fismo|G-LOC R12/R10|Zeta III L|NLR Wing and Splitter|CJM Pan and Fuel Hat|Radium Surge Tank|AP Racing CP9668 |
05-15-2021, 01:34 AM | #23 (permalink) | |
Enthusiast Member
Join Date: Jun 2016
Location: GTA
Posts: 368
Drives: 2010-Red-6spd-S/T
Rep Power: 15756 |
Quote:
__________________
2FT3PDLZ |
|
05-15-2021, 03:01 PM | #24 (permalink) | |
Base Member
Join Date: May 2019
Location: Paris
Posts: 77
Drives: Nissan 370z
Rep Power: 6 |
Quote:
The problem it's when my engine is hot. Engine oil is often at 110-115 degrees in traffic or sporty driving. I often drive on roads without speed limits (at germany ). This is why I would like to know if it is good for engine to drive with 5w40 oil throughout the year. Last edited by brainrain; 05-15-2021 at 03:04 PM. |
|
05-15-2021, 05:05 PM | #26 (permalink) |
Premium Member
Join Date: Nov 2010
Location: South Arkansas
Posts: 8,435
Drives: 2014 Challenger
Rep Power: 324198 |
Nissan (and all other car makers) engineers spend at least a little bit of time and money figuring out which oil viz works best in each engine. Plus they have a lot of experience. And engines are a LOT pickier than they were back in The Good Old Days of iron blocks and carburetors. I'll go with what they recommend.
But, as mentioned above, a few cSt here or there on the W end isn't going to make that much difference. But you can go too far.
__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma |
05-15-2021, 05:19 PM | #27 (permalink) |
Base Member
Join Date: May 2019
Location: Paris
Posts: 77
Drives: Nissan 370z
Rep Power: 6 |
Nissan dealer in south of France recommend 5w40.
I was a little surprised because all people in this forum recommended 5w30 oil, despite the high temperatures in summer in the United States. I discussed with some owners in France, most use 5w40. But we aren’t many to have a feedback on the reliability of the engine with this oil. |
05-15-2021, 09:17 PM | #28 (permalink) |
Ronin Samurai - Assassin
Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 68
Posts: 35,187
Drives: 2011 Nismo GM 6M
Rep Power: 2684437 |
__________________
浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html |
05-16-2021, 12:22 AM | #29 (permalink) | |
Premium Member
Join Date: Nov 2010
Location: South Arkansas
Posts: 8,435
Drives: 2014 Challenger
Rep Power: 324198 |
Quote:
As the chart above shows, once the temp gets over 100C or so, the difference in viscosity is very little and which viz you use is not that important. Below about 60C, the difference in viz can cause higher pressure, more strain on the oil pump, and a little less flow through the system. Moving up 10 probably won't make much differerence unless you really push the engine when cold, but why risk it. This is for DDs. You track guys operate under different conditions.
__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma |
|
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 06:47 AM |
Nissan Motorsports Oil Cooler vs. Stillen Oil Cooler | Dustin@Z1 | Engine & Drivetrain | 158 | 03-10-2014 03:27 PM |
STILLEN oil cooler kit + STILLEN power steering cooler = fit? | ZBW39 | STILLEN | 2 | 07-02-2010 02:08 PM |
Oil Cooler.....Trans Cooler... | kannibul | Engine & Drivetrain | 6 | 12-31-2009 07:32 PM |
Oil cooler | Zeto | STILLEN | 6 | 04-20-2009 08:08 PM |