S-Mode and gear indicator going out, lagging acceleration

Uxi · 10-29-2024, 06:03 PM

Put this in general and nothing.

Just recently, S-mode light started going out. Before that, something is "lagging" where I'll have the pedal down hear the engine revving but then the tach will jump from 3000-5000 then the gear indicator and s-mode light will go out. There isn't an S-mode warning until I hit the s-mode button.

After that, seems to rev normally but still feels and sounds a bit... off. Almost sounds like the engine is higher pitch if that makes sense. Or maybe louder.
I'm not getting the 'lag' after that, but it does appear that there is little to no acceleration before 3000 rpm that I don't think I've noticed before.

If I turn the car off it will come back with no warnings. Brake fluid seems normal. Sounds like a bad sensor or something else?

Drove a day with S-mode off and seemed better but still louder. Now it did the lagging from 3500 to 4500 again and the gear shift with S-mode off and the gear shift indicator went out. Think my clutch is slipping? Gonna take it to a mechanic tomorrow.

Uxi · 11-12-2024, 12:17 PM

Took it to a mechanic. He said he thinks the clutch is skipping. OS Giken STR installed March 2023 when my CSC went out again with the CMAK. Mechanic called and said the codes are telling him input/output shaft correlation or something to that effect and that he had to pull the transmission to check the clutch.

Called me on Saturday and said the clutch is burned. Can't tell me the cause (bad part, bad install or what) and is recommending a new clutch. I'm asking if an OS Giken overhaul kit would be enough but he's not sure nor the difference between overhaul kit A and B and if it the pressure plate is good or not.

https://osgikenusa.com/products/ns11...30261988491347

Anyone have any ideas?

10-29-2024, 06:03 PM	#1 (permalink)
Uxi Enthusiast Member Join Date: Apr 2015 Location: Southern California Posts: 303 Drives: 16 NISMO Tech PW 6MT Rep Power: 3598	S-Mode and gear indicator going out, lagging acceleration Put this in general and nothing. Just recently, S-mode light started going out. Before that, something is "lagging" where I'll have the pedal down hear the engine revving but then the tach will jump from 3000-5000 then the gear indicator and s-mode light will go out. There isn't an S-mode warning until I hit the s-mode button. After that, seems to rev normally but still feels and sounds a bit... off. Almost sounds like the engine is higher pitch if that makes sense. Or maybe louder. I'm not getting the 'lag' after that, but it does appear that there is little to no acceleration before 3000 rpm that I don't think I've noticed before. If I turn the car off it will come back with no warnings. Brake fluid seems normal. Sounds like a bad sensor or something else? Drove a day with S-mode off and seemed better but still louder. Now it did the lagging from 3500 to 4500 again and the gear shift with S-mode off and the gear shift indicator went out. Think my clutch is slipping? Gonna take it to a mechanic tomorrow.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
S-Mode and gear indicator going out, lagging acceleration	Uxi	Nissan 370Z General Discussions	0	10-25-2024 04:18 PM
gear indicator	370-ZYA	370ZBlog	3	07-25-2022 08:25 PM
No current gear indicator on non-sport?	edconline	Nissan 370Z General Discussions	22	04-19-2014 08:15 AM
Initial acceleration dip (lag) in 1st gear	Auston	Engine & Drivetrain	15	01-31-2011 04:58 PM
Is there still a gear indicator on non S-mode (i.e. non sports package) 6MT models?	k.alexander	Nissan 370Z General Discussions	17	02-22-2009 04:34 PM

11-12-2024, 12:17 PM	#2 (permalink)
Uxi Enthusiast Member Join Date: Apr 2015 Location: Southern California Posts: 303 Drives: 16 NISMO Tech PW 6MT Rep Power: 3598	Took it to a mechanic. He said he thinks the clutch is skipping. OS Giken STR installed March 2023 when my CSC went out again with the CMAK. Mechanic called and said the codes are telling him input/output shaft correlation or something to that effect and that he had to pull the transmission to check the clutch. Called me on Saturday and said the clutch is burned. Can't tell me the cause (bad part, bad install or what) and is recommending a new clutch. I'm asking if an OS Giken overhaul kit would be enough but he's not sure nor the difference between overhaul kit A and B and if it the pressure plate is good or not. https://osgikenusa.com/products/ns11...30261988491347 Anyone have any ideas?