ECUTEK/UPREV idle relearn
 

Hello everyone, is it possible to force an idle relearn on swaps?

Playing around with Ecutek on my swap I tried doing an idle relearn however it was unsuccessful. I idle around 750-800rpm/ 18% load after warm up(no codes) which is fine however it peeked my curiosity since Ecutek has the ability however some swaps wouldn't have IPDM, hood switch and other requirements "needed" for the relearn.

So far disconnecting/connecting throttles dont act like a Z/G where on some occasions requires the relearn, mine's coldstarts and goes through the warm up process just like OEM however stays at 750-800rpm instead of the 650-700rpm that usually see which doesnt bother me however makes me question if this is due to the lack of the learn which at the moment seems unobtainable.

Thanks in advance.

I dont know about swaps, but you can run the ECUtek relearn from the phone. I have never got it to work properly, but my car will auto learn after an ECM reset.


idk if that's any help.

Same here, it will "auto relearn" to a point however from the phone it will not work.

750 to 800 is ok tbh. it depends on your setup though.

I'm happy with it however I own a G37 and wonder if the remaining 100rpm is would be achieved by the relearn or other possible aspects.

I prefer the higher RPM but wonder about other's results.