ZSpeed CMAK with a RJM clutch pedal??
 

Couldn't find this on a search,but do these 2 components work well together?Currently have my RJM pedal installed,the APF setting is at 50%,is that a good place to start and can the CMAK be bled at that setting,or would I have to slide it to the stock setting (0%) to do that like the stock CSC?Do not have the CMAK as of yet.

They work well together. Ask Ryan at RJM about the best settings for bleeding. He's always very helpful and is familiar with the CMAK unit.

From the Rev 3.x instruction manual on RJM's website:

Thanks.....I believe these instructions were intended for the stock clutch/csc set-up,but I did contact Ryan at RJM and the same applies for the CMAK set-up as well(setting APF at 0% for bleeding).Joe at ZSpeed recommends leaving the RJM pedal in the stock APF (0%)position after the bleeding is complete.Ryan at RJM says u can adjust it to the 50-75% APF setting with the ZSpeed clutch/CMAK after the bleeding is complete.I am going to try it out at the stock 0% first and maybe bump it up to 25-50% if I want to change the feel a bit.

It sounds like it's safest at 0% (or just using a power bleeder if you have one) but you can keep it at 50-75% if you have a CMAK. If that's the way you like it, it's more convenient to leave it at that setting while you bleed, but if you have to adjust it anyway, you might as well adjust it to 0 to be safest.

Is that the gist of it?

With the CMAK the APF setting has to be set to 0% to do a proper bleed just like the stock system.