Any turn key built motors?
 

Looking to go forced induction eventually and my end goal is 800whp. I know a slight amount about built motors and am curious if there are any turn key motors that can support this power? I was looking at IPT's engines and their stage 3 long block but I don't know what else I would need to get the engine running with my FI TT kit.

wow 373 views no replies lol.... does no one know anything abt this subject am i posting in the wrong spot?

Forced Induction - Nissan 370Z Forum

Post it in the forced induction section should yield more responses

All I have to say is www.Mazworx.com You are right at that HP level that blows headgaskets. Want to do it twice? It's not fun. You can read my thread and find out how fun it is.

Call SOHO Motorsports in North Carolina. George will likely be the 1 to pick the phone up. Him or Nik, either 1 can help with whatever you need.

Your only other high level option is Mazworx like Spooler mentioned.

Whoa as recently as mid Sept, OP was only aiming at 520whp. 800whp range is a whole new can of worms for this motor, as two posts above suggest.

Go to Soooler’s thread, read, then read, then read again, that journal is the truth, no lies no bs. You won’t find any other FI thread at this whp level that openly discloses every failure and solution like Spooler did.

Best of luck!

I had someone ask me why I shared so much. I don't know, That's just who I am. If someone wants to gain knowledge, it is there for the taking.

Thank you! I figured if I am going FI I should go all the way!

Hey .. i hope you found a garage .. but most of the people i know who runs 800 to 900 hp vq they all blowed up the motors many times .. its too risky on these motors to be reliable at 800hp easiest thing you can do is swap the motor to vr38 out of any gtr and on stock turbos you can make 800 hp and it will be reliable ..i hope it helps

New things have been tried and are working like a champ. Not sure who built the people you know motors. VR38's blow up also.

Just bad information.

Yeah, there is lots of that going on.

What did you expect.........facecrap. :facepalm:

Just look at some of the new posts. :icon14:

Mazworx long block stage 3 motor is only $15K opposed to Soho HB $20K.

Is the extra $5K soho hb worth it over the Mazworx?

AAM has shortblocks and longblocks. Although, I’d go Mazworx.

Yea I don't know about AAM Blocks, almost never heard any feedback about them from any source. Whereas, Mazworx and soho have tons of feedback and success it seems.

Dynosty was doing VQ stuff but been years since I've seen any new builds from them. I know they had a couple closed deck blocks they were building.

I would definitely not recommend using AAM for their short blocks.

Seb/Dynosty/CSS should be good or Mazworx. Soho is good aswell but who wants to spend 25k for a VQ lmao

SOHO is the place to go for this issue; They have a video on youtube that discusses this very problem and why it occurs.

If I were doing a built motor, I'd just ship the carto SOHO and a briefcase full of cash! :driving:

This: https://www.youtube.com/watch?v=3Bi_bb5zc4Y