ok! back story. I changed out plugs and cleaned my TBs, I did manipulate the flanges of the TBs but only a little and I did not disconnect the Tbs
|
|
LinkBack | Thread Tools | Display Modes |
01-22-2020, 10:13 PM | #1 (permalink) |
Base Member
Join Date: Dec 2016
Location: Georgia
Posts: 2
Drives: 2010 370z 40th anv
Rep Power: 9 |
HELP! z will not run after tb clean
ok! back story. I changed out plugs and cleaned my TBs, I did manipulate the flanges of the TBs but only a little and I did not disconnect the Tbs at all. I did the idle air learn procedure after and it idles fine. Now the problem. under load or at a stop if I rev the engine too hard or rpms too high its like the motor goes into some kind of mode. the idle bounces between 1000-1100 rpm with no throttle response at all, also the vdc off light and traction light constantly displays when this happens. If I do the idle air re learn it will go back to idling normally and responsive until I do the same thing and will go back into this same mode. MAFs are clean and plugs are new and gapped correctly. HELP!
here is a link to my video of the care rev under this situation https://youtu.be/HSw09F00i7k |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Are you OCD about a clean Z? | Spooler | Detailing / Washing / Waxing / Cosmetic Maintenance and Repair | 54 | 09-25-2014 03:54 PM |
My clean Z :-) | GalletGun | Detailing / Washing / Waxing / Cosmetic Maintenance and Repair | 5 | 12-22-2013 08:35 AM |
how to clean titanium ? | zuperman 370 | Detailing / Washing / Waxing / Cosmetic Maintenance and Repair | 1 | 04-21-2011 07:47 PM |
How do i clean these?? | Osiris | Detailing / Washing / Waxing / Cosmetic Maintenance and Repair | 8 | 01-30-2011 08:18 PM |
How do u clean | thispecialk | Exterior & Interior | 3 | 07-20-2009 01:33 AM |