Electronics won’t let me start my Z and OBD port and ECU won’t connect. Need a mechan

2013-Z33 · 10-22-2019, 11:14 AM

At some point there was a weak or lost ground from the ECU to the engine. This can cause the ignition coil's built in driver to overheat and short in a way that causes the input of the driver to short to the output, which is the negative side of the coil's primary. At this point as the ECU's output tries to drive the coil's input low and it "sees" +12v through the coil's primary, which has a resistance of about 1 ohm. The ECU's coil output pin is now trying to switch over 10 amps to ground. The battery wins and smokes the ECU's driver which is only rated for 0.05 A. The driver is part of an IC that has about 30 other channels. That coil channel will be blown for sure but usually some other's are as well, but in a random pattern that is not always the same. Some of the other I/O channels; CAN, fuel pump, OBD2...etc. Even when the ECU's ground is restored the shorted coil(s) remain and if a new ECU is installed and powered on the same damage happens again. Unplug all of the coils from the harness and try another
ECU.

10-22-2019, 11:14 AM	#13 (permalink)
2013-Z33 Base Member Join Date: Apr 2013 Location: LA Posts: 8 Drives: 13 370Z Rep Power: 3367	At some point there was a weak or lost ground from the ECU to the engine. This can cause the ignition coil's built in driver to overheat and short in a way that causes the input of the driver to short to the output, which is the negative side of the coil's primary. At this point as the ECU's output tries to drive the coil's input low and it "sees" +12v through the coil's primary, which has a resistance of about 1 ohm. The ECU's coil output pin is now trying to switch over 10 amps to ground. The battery wins and smokes the ECU's driver which is only rated for 0.05 A. The driver is part of an IC that has about 30 other channels. That coil channel will be blown for sure but usually some other's are as well, but in a random pattern that is not always the same. Some of the other I/O channels; CAN, fuel pump, OBD2...etc. Even when the ECU's ground is restored the shorted coil(s) remain and if a new ECU is installed and powered on the same damage happens again. Unplug all of the coils from the harness and try another ECU. JARblue, Rusty, Optimiser and 4 others like this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
370Z Nismo, engine stops and won’t start	Morfiy	Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs	3	05-01-2019 11:45 AM
370z washer fluid won’t pump through/ Clutch won’t disengage	Nerminmah	Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs	3	05-24-2018 05:59 PM
2012 nismo 370z won’t start after gascap change	Datnismo3323	Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs	4	03-03-2018 12:15 AM
Car won’t start	Zthirty4NISMO	Nismo 370Z	9	08-03-2016 06:35 PM