3d printed AN bung?
 

Probably not the right section but it's valve cover related?

Using hose clamps on braided AN hose is just...not for me. I was thinking about 3d printed 8AN male bungs with a stepped ID bore to slide over the valve cover breather ports and epoxy on. Or maybe having some machined from delrin?

I know you couldn't crank down on the fittings but it would make for a "cleaner" connection?

Am I barking up the wrong tree?

They sell AN hose ends that have a hidden hose clamp inside. I suppose you could put one on the hose, bore out the other one and fit it over the breather tube for a cleaner look? Or just the one on the hose?

My old ones looked like this (red)https://uploads.tapatalk-cdn.com/201...cb63d9c668.jpg

Sent from my SM-G955U using Tapatalk

Yeah I know about those clamps. I guess those are probably my best bet.

Check your PM!