|
Unsure the clutch you had installed; helped a buddy of mine do his...used a rethreader to clean up all bolts & holes from clutch,flywheel,crank & trans bell housing (very helpful)
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-19-2019, 03:53 AM
|
#8 (permalink) |
|
A True Z Fanatic
Join Date: Nov 2014
Location: South Carolina
Age: 58
Posts: 15,204
Drives: 13’ 370Z TS 7A/T
Rep Power: 2684395   |
Unsure the clutch you had installed; helped a buddy of mine do his...used a rethreader to clean up all bolts & holes from clutch,flywheel,crank & trans bell housing (very helpful)
Also old pilot bushing was slightly egged & used a flywheel holding tool to evenly pull up & torque new flywheel. Another member suggested this/ as this could pose an issue if it’s not pulled up flush. Afterwards ~ Tranny slid back in very easily,,,but we did have to tweak adjustment on cmak for smooth/even operation before assembly.
__________________
MazWorx built long block | FI-TT-100 Stage 2.75 | IPT built 7A/T http://www.the370z.com/members-370z-...s-musings.html |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| So my 6mt VQ37 6th gear transmission is grinding ... | CL_hiro_g37s | Engine & Drivetrain | 2 | 04-02-2016 03:49 PM |
| 5th Gear Grinding = New Transmission | dozerdc | Mid-Atlantic Region | 13 | 12-08-2012 10:01 AM |
| Grinding Noise | christian370z | Brakes & Suspension | 9 | 12-12-2010 11:44 AM |
| transmission grinding? | Daishi | Engine & Drivetrain | 23 | 01-20-2010 05:43 AM |
| Manual transmission grinding (not a Z) | kannibul | Other Vehicles | 6 | 11-09-2009 09:50 PM |
3Likes
Threaded Mode
