Nissan 370Z Forum  

Reusing CSC when changing the transmission?

I put in a new clutch kit, Zspeed CSC, and master cylinder early last year. Now it's rough going into gear and the rear section of the trans has a

Go Back   Nissan 370Z Forum > Nissan 370Z Tech Area > Engine & Drivetrain


Reply
 
LinkBack Thread Tools Display Modes
Old 12-14-2018, 03:37 PM   #1 (permalink)
Base Member
 
Join Date: Mar 2016
Location: Virginia
Posts: 72
Drives: [SOLD] 09 Tour/Sport
Rep Power: 3364
Ben370 has a reputation beyond reputeBen370 has a reputation beyond reputeBen370 has a reputation beyond reputeBen370 has a reputation beyond reputeBen370 has a reputation beyond reputeBen370 has a reputation beyond reputeBen370 has a reputation beyond reputeBen370 has a reputation beyond reputeBen370 has a reputation beyond reputeBen370 has a reputation beyond reputeBen370 has a reputation beyond repute
Default Reusing CSC when changing the transmission?

I put in a new clutch kit, Zspeed CSC, and master cylinder early last year.

Now it's rough going into gear and the rear section of the trans has a small leak so I know that's bad.

The service manual says to replace the CSC whenever changing the trans but it that necessary with the Zspeed one?

Quote:
TM-12
Never reuse CSC (Concentric Slave Cylinder) body and CSC tube. Because CSC slides back to the
original position every time when removing transmission assembly. At this timing, dust on the sliding
parts may damage a seal of CSC and may cause clutch fluid leakage.
Ben370 is offline   Reply With Quote
Old 12-14-2018, 03:40 PM   #2 (permalink)
Premium Member
 
Jayhovah's Avatar
 
Join Date: May 2013
Location: St. Pete, FL
Posts: 3,848
Drives: 520whp Fire Breather
Rep Power: 86951
Jayhovah has a reputation beyond reputeJayhovah has a reputation beyond reputeJayhovah has a reputation beyond reputeJayhovah has a reputation beyond reputeJayhovah has a reputation beyond reputeJayhovah has a reputation beyond reputeJayhovah has a reputation beyond reputeJayhovah has a reputation beyond reputeJayhovah has a reputation beyond reputeJayhovah has a reputation beyond reputeJayhovah has a reputation beyond repute
Default

You should be good to reuse, but give Joe@Zspeed a call and confirm =)
__________________
2013 Gun Metallic Sport - Gamma V3 Twin Turbogized
DIY Gamma V3 TT Install * Jayhovah's Gamma V3 TT Install Pic'Z and Vid'Z * DIY: Washer Reservoir for the Boosted
Quote:
Originally Posted by redondoaveb
You've got a twin turbo sound system, I think you met your audio goals.
Jayhovah is offline   Reply With Quote
Old 12-14-2018, 03:57 PM   #3 (permalink)
A True Z Fanatic
 
Join Date: Jun 2014
Location: Ga
Posts: 13,834
Drives: 2013 Nismo 370z
Rep Power: 2684392
Spooler has a reputation beyond reputeSpooler has a reputation beyond reputeSpooler has a reputation beyond reputeSpooler has a reputation beyond reputeSpooler has a reputation beyond reputeSpooler has a reputation beyond reputeSpooler has a reputation beyond reputeSpooler has a reputation beyond reputeSpooler has a reputation beyond reputeSpooler has a reputation beyond reputeSpooler has a reputation beyond repute
Default

If it is still in the bellhousing I would change it out again. If you did the external CSC upgrade, I wouldn't worry about it.
Spooler is offline   Reply With Quote
Old 12-15-2018, 11:20 AM   #4 (permalink)
A True Z Fanatic
 
DOOMMONKEY777's Avatar
 
Join Date: Oct 2010
Location: Crooklyn
Posts: 1,008
Drives: 370Z 6psd-sport-pkg
Rep Power: 21
DOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond reputeDOOMMONKEY777 has a reputation beyond repute
Default

you need to change the wear-out bearing, make sure you have the right one for the clutch you are using, some clutches like twin disks require a special wear-out bearing for example.
__________________
Kids don't do Drugs, Drugs are bad, so let the professional druggies do Drugs for you. 537whp/496lb/tq@8-9PSI 93 octane
DOOMMONKEY777 is offline   Reply With Quote
Reply

Bookmarks


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Is a transmission rebuild done any differently for a sports mode manual transmission? NismoNY Engine & Drivetrain 4 04-01-2015 08:57 AM
Transmission problem (?) after a transmission fluid change EWarren Engine & Drivetrain 7 07-28-2014 12:44 PM
Changing brakes would these fit? zellsexy Brakes & Suspension 1 03-01-2013 01:50 PM
Changing User Name DivZero The Lounge (Off Topic) 1 09-22-2011 01:39 AM
Changing the oil Muse284 Engine & Drivetrain 6 01-13-2011 06:54 PM


All times are GMT -5. The time now is 06:15 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2