2011 6mt died when coming to a stop, wont start

sidewinder_x5 · 11-13-2018, 09:33 PM

Quote:

Originally Posted by Rusty

What year motor? Newer years have the updated gaskets.

was going to get a 2012+ motor to avoid this happening again.

Quote:

Originally Posted by Spooler

Sorry to hear that. Used motors in good shape can run up to $1700. Make sure to have a water pump and galley gaskets installed before they put it in the car. Just a little insurance.

sounds good. will do.

BettyZ · 11-14-2018, 05:42 PM

Quote:

Originally Posted by sidewinder_x5

made that exact noise under acceleration. guess i found the culprit. its a 2011

this is my current plan, considering the labor for replacing the engine comes to $2600, which i find surprising, especially at a dealer.

my plan is to get a decent condition used motor, a better clutch, headers, and an exhaust and get all that installed while theyre replacing the motor.

My two cents: the OEM headers are well designed and unless you're going for long tube headers - which means deleting your catalytics, which could be a problem in your state - non-LTH aftermarket headers dont have a good cost-benefit ratio.

If you havent yet, get the CMAK kit with a new clutch and flywheel from ZSpeed. And consider a mild wire re-loom and tuck while the engine's out!

Sent from my SM-G955U using Tapatalk

henry0844 · 12-15-2018, 05:23 PM

Quote:

Originally Posted by Spooler

Sorry to hear that. Used motors in good shape can run up to $1700. Make sure to have a water pump and galley gaskets installed before they put it in the car. Just a little insurance.

or the op could do what i did and just get a motor that is from 2012 model year and up. that way you don't have to open up anything on the motor, just install and enjoy.

Rusty · 12-22-2018, 01:59 PM

Quote:

Originally Posted by henry0844

or the op could do what i did and just get a motor that is from 2012 model year and up. that way you don't have to open up anything on the motor, just install and enjoy.

You take all the fun out of it.

I love cracking motors open.

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
2009 Car died on me when I came to a stop.	Joe Perry	Engine & Drivetrain	4	11-09-2018 07:59 AM
Car Died While Driving, Now Will Not Start. No Codes.	ShaunB828	Engine & Drivetrain	22	11-19-2017 05:21 AM
Key wont unlock, car wont start	shaun1189	Nissan 370Z Warranty / Scheduled Maintenance / Servicing / Repairs	5	07-13-2017 05:21 PM
Fufunfun STOP!! A Z died today...	dant1127	Engine & Drivetrain	19	11-11-2014 12:37 PM
370z wont start no power . Where to start	acracing118	Exterior & Interior	6	01-05-2013 06:37 PM