Where's the OE fuel pump relay? It's not in the fuse box at the battery, by the ecu nor fuel pump and can't find it in the owners nor repair
|
|
LinkBack | Thread Tools | Display Modes |
09-02-2018, 11:54 AM | #1 (permalink) |
A True Z Fanatic
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,326
Drives: '10 K23 ST 7AT
Rep Power: 30525 |
Sputtered to Stop......Now Runs Fine.
Where's the OE fuel pump relay? It's not in the fuse box at the battery, by the ecu nor fuel pump and can't find it in the owners nor repair manual on Nico website.
179 miles into a 180 mile trip and with 1/2 tank of fuel (later physically confrimed) mine sputtered twice then turned off as if running out of fuel. I shut the ignition off then back on and didn't hear the fuel pump prime. The next day I went back to it, keyed on, fuel pump primed, it started and drove fine for the last mile to my destination. New Fuel pump motor only (OE) and pick up sock replaced approx. 3k miles ago, never run the tank below 1/4 on the gauge, physically pulled the entire assembly a few minutes ago and it's full intact. No wires loose, no hoses coming off nor split, no junk on the sock and no crap in the bottom of the tank. No codes present. Scouring the manual for a fuel pump driver module or relay etc. now. Kinda hesitant to drive home and get stuck on the highway. Any other insight would be greatly appreciated.
__________________
Toys Not Tots Last edited by Tractionless; 09-02-2018 at 01:51 PM. |
09-02-2018, 05:49 PM | #2 (permalink) |
A True Z Fanatic
Join Date: Oct 2010
Location: Crooklyn
Posts: 1,008
Drives: 370Z 6psd-sport-pkg
Rep Power: 21 |
Did you make a HARD long right turn, this is a Z fuel tank problem, not enoughf baffles all the fuel goes to the left side and starves the pump on the right, this has been reported to happen with 3/4 tank full, CJM ans Z1 motorsports has a solution for this, gl pal.
__________________
Kids don't do Drugs, Drugs are bad, so let the professional druggies do Drugs for you. 537whp/496lb/tq@8-9PSI 93 octane |
09-02-2018, 06:17 PM | #3 (permalink) | |
A True Z Fanatic
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,326
Drives: '10 K23 ST 7AT
Rep Power: 30525 |
Quote:
I’ll check into that fix for future needs though.
__________________
Toys Not Tots |
|
09-02-2018, 08:35 PM | #4 (permalink) |
Premium Member
Join Date: Nov 2010
Location: South Arkansas
Posts: 8,435
Drives: 2014 Challenger
Rep Power: 324198 |
Did you check the lid of the IPDM? It shows location of fuses and relays inside the IPDM. The relay may be buried under something else. If it's not in the IPDM, the FSM (if you can find a copy; Nissan sent out take-downs to the sites that were hosting it) will tell you where it's located. Or wait a little bit and someone else will chime in.
__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma |
09-03-2018, 11:38 AM | #5 (permalink) | |
A True Z Fanatic
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,326
Drives: '10 K23 ST 7AT
Rep Power: 30525 |
Quote:
__________________
Toys Not Tots |
|
09-03-2018, 11:41 AM | #6 (permalink) | |
A True Z Fanatic
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,326
Drives: '10 K23 ST 7AT
Rep Power: 30525 |
Quote:
I confirmed 7 gallons of fuel in the tank upon filling it up last night before driving home 180 miles without issue. If that sort of turn with 7 gallons of gas in the tank is going to cause this type of issue I'm incredibly disappointed with this car! And $500 for the Anti-Starvation kit from Z1 is a complete customer rip off for a pump that costs $65 everywhere online.
__________________
Toys Not Tots Last edited by Tractionless; 09-03-2018 at 11:44 AM. |
|
09-03-2018, 11:47 AM | #7 (permalink) |
Premium Member
Join Date: Nov 2010
Location: South Arkansas
Posts: 8,435
Drives: 2014 Challenger
Rep Power: 324198 |
If you have a buddy that knows how to use a soldering iron (a dying art), he/she should be able to replace the relay.
__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma |
09-03-2018, 12:42 PM | #8 (permalink) | |
A True Z Fanatic
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,326
Drives: '10 K23 ST 7AT
Rep Power: 30525 |
Quote:
I was also just reading the Track section of the forum where owners had secondary pumps mounted in the drivers side of the tank (LIKE the Z1 kit) and removed them due to overheating. I don't know that I'd have that issue considering I'm not tracking and never run the tank below 1/4 level though. Again, the Z1 kit is just very expensive for what's included, hard pill to swallow. I'd love to find a solution using just fuel tank foam. Searched foam over in the track section and it doesn't look like anyone's been successful in that endeavor though.
__________________
Toys Not Tots |
|
09-03-2018, 02:46 PM | #9 (permalink) |
Premium Member
Join Date: Nov 2010
Location: South Arkansas
Posts: 8,435
Drives: 2014 Challenger
Rep Power: 324198 |
Maybe someone will post a wiring diagram or other info to find the relay location.
__________________
Steering Lock Links - Search The370Z Bookmarklet - FSM @ NICOclub Mankind has progressed past the need for war but we haven't evolved that far. - NachoMahma |
09-03-2018, 03:42 PM | #10 (permalink) |
A True Z Fanatic
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,326
Drives: '10 K23 ST 7AT
Rep Power: 30525 |
Workshop manual shows it in the wiring diagram but not a physical location within the IPDM. I scoured the workshop manual, owners manual, google, this site, and FB yesterday for 2.5 hrs. to no avail.
__________________
Toys Not Tots |
09-05-2018, 11:40 PM | #13 (permalink) | |
Ronin Samurai - Assassin
Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 68
Posts: 35,220
Drives: 2011 Nismo GM 6M
Rep Power: 2684438 |
Quote:
I believe you had fuel starve. You're not the first to have it or the last.
__________________
浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html |
|
09-06-2018, 09:21 AM | #14 (permalink) | |
A True Z Fanatic
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,326
Drives: '10 K23 ST 7AT
Rep Power: 30525 |
Quote:
__________________
Toys Not Tots |
|
09-11-2018, 01:33 AM | #15 (permalink) |
Base Member
Join Date: Jan 2012
Location: Atlanta, GA
Posts: 6
Drives: 11 Nissan 370Z wb m6
Rep Power: 13 |
Go to Autozone or O'Reiley's and get a free OBD2 scan. My hometown Nissan tech advisor I built a great rapport with told me it could possibly be my vtc sprocket sticking. My Z is @ 100k miles and I just installed new camshaft position sensors. Will get a thorough sensor scan at the Nissan dealership and update you.
__________________
Leon Third Coast Customs Atlanta |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
CAI are fine | Mt Tam I am | Intake/Exhaust | 12 | 12-30-2010 11:36 AM |
Might Fine Burger Meet | theDreamer | Texas | 29 | 04-22-2010 12:39 PM |
Help fine me a HU | theDreamer | Audio & Video | 7 | 08-13-2009 11:08 AM |
Fine Dining Information NY/NJ | CrownR426 | North East Region | 1 | 04-15-2009 08:48 PM |